P1448 Infiniti EVAP Canister Vent Control Valve Open
Possible causes
– EVAP canister vent control valve
– EVAP canister is saturated with water
– EVAP control system pressure sensor and the circuit
– Blocked rubber tube to EVAP canister vent control valve
– Water separator
– EVAP canister is saturated with water
– EVAP control system pressure sensor and the circuit
– Blocked rubber tube to EVAP canister vent control valve
– Water separator
Tech description
Start by checking for damage EVAP canister or hoses. If no hoses are damage the EVAP canister vent control valve may have to be replaced.
What about the obd code?
EVAP canister vent control valve remains open under specified driving conditions.
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
P1448 Infiniti Description
The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent.
This solenoid valve responds to signals from the ECM. When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal the canister vent. The ability to seal the vent is necessary for the on board diagnosis of other evaporative emission control system components.
This solenoid valve is used only for diagnosis, and usually remains opened. When the vent is closed, under normal purge conditions, the evaporative emission control system is depressurized and allows EVAP Control System (Small Leak)diagnosis.
Infiniti Vehicle:Infiniti EX35,Infiniti FX35,Infiniti FX50,Infiniti G25,Infiniti G37,Infiniti M35,Infiniti M37,Infiniti M56,Infiniti QX562013 Infiniti,2012 Infiniti,2011 Infiniti,2010 Infiniti,2009 Infiniti,2008 Infiniti,2007 Infiniti,2006 Infiniti,2005 Infiniti,2004 Infiniti,2003 Infiniti,2002 Infiniti,2001 Infiniti,2000 Infiniti,1999 Infiniti,1998 Infiniti,1997 Infiniti,1996 Infiniti,