P0732 Audi Gear 2 Incorrect Ratio
Possible causes
– Low transmission fluid level
– Dirty transmission fluid
– Faulty Shift Solenoids
– Shift Solenoids harness is open or shorted
– Shift Solenoids circuit poot electrical connection
– Transmission mechanical problems
– Transmission hydraulic control circuit
– Dirty transmission fluid
– Faulty Shift Solenoids
– Shift Solenoids harness is open or shorted
– Shift Solenoids circuit poot electrical connection
– Transmission mechanical problems
– Transmission hydraulic control circuit
Tech description
Start by inspecting the transmission fluid level and condition, and change fluid if necessary.
What about the obd code?
P0732 Audi is detected when A/T cannot be shifted to the 2nd gear position even if electrical circuit is good.
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
– Incorrect transmission shifting
– Incorrect transmission shifting
P0732 Audi Description
This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:
Torque converter slip ratio = A x C/B
A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes
If the actual gear position is higher than the position (2nd) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.
Audi Vehicle:Audi A1,Audi A3,Audi A1,Audi A3,Audi A1,Audi A3,Audi A4,Audi A5,Audi Q3,Audi A5,Audi Q5,Audi A3,Audi A4,Audi A5,Audi TT,Audi Q3,Audi Q5,Audi S3,Audi TTS,Audi RS 3,Audi TT RS,Audi A7,Audi Q7,Audi A8,Audi A6,Audi S4,Audi S5,Audi Q5,Audi S6,Audi S8,Audi S5,Audi A8,Audi R8 V8,Audi RS 5,Audi S6,Audi R8 V10,Audi R8 GT,Audi A8L