P0057 Peugeot HO2S22 Heater Control Circuit Low

P0057 Peugeot HO2S22 Heater Control Circuit Low

Possible causes
– Faulty Heated Oxygen Sensor (H2OS) Bank 2 Sensor 2
– Heated Oxygen Sensor (H2OS) Bank 2 Sensor 2 harness is open shorted
– Heated Oxygen Sensor (H2OS) Bank 2 Sensor 2 circuit poor electrical connection
– Heated Oxygen Sensor (H2OS) Bank 2 Sensor 2 circuit fuse
– Faulty Engine Control Module (ECM)
Tech description
The code means that there is a problem with the heater element circuit of the heated oxygen sensor. Water getting inside the heated oxygen sensor connector can caused the heated oxygen sensor fuse to blow, which is a very common problem for this type codes. Before replacing the sensor, check for the condition of the heated oxygen sensor fuse and connectors.
What about the obd code?
The P0057 Peugeot is set when the ECM detects an excessively low voltage through the heated oxygen sensor heater circuit
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
P0057 Peugeot Description

Oxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. The faster the heated oxygen sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).

In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.

The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.

Peugeot Vehicle:Peugeot 107,Peugeot 208,Peugeot 408,Peugeot 508,Peugeot RCZ,Peugeot 4007,Peugeot Expert Tepee
CategoriesUncategorized