Mazda DTC P0610 Diagnostic

DTC P0610

 

  

PCM vehicle options error

 
DETECTION CONDITION

• PCM data configuration error.

Diagnostic support note

• This is a continuous monitor (CCM).

• The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.

• PENDING CODE is available if the PCM detects the above malfunction condition.

• FREEZE FRAME DATA is available.

• The DTC is stored in the PCM memory.
POSSIBLE CAUSE

• Configuration procedure has not been completed

• PCM malfunction

Diagnostic procedure

 
 

STEP

 

  

INSPECTION

 

  

ACTION

 

1
 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED

• Has FREEZE FRAME DATA been recorded?

Yes

Go to the next step.

No

Record the FREEZE FRAME DATA on the repair order, then go to the next step.

2
 VERIFY RELATED REPAIR INFORMATION AVAILABILITY

• Verify related service repair information availability.

• Is any related repair information available?

Yes

Perform repair or diagnosis according to the available repair information.

• If the vehicle is not repaired, go to the next step.

No

Perform the “PCM CONFIGURATION”, then go to the next step.

3
 VERIFY TROUBLESHOOTING OF DTC P0610 COMPLETED

• Make sure to reconnect all disconnected connectors.

• Clear the DTC from the PCM memory using the WDS or equivalent.

• Start the engine.

• Is the same DTC present?

Yes

Replace the PCM, then go to the next step.

No

Go to the next step.

4
 VERIFY AFTER REPAIR PROCEDURE

• Perform the “AFTER REPAIR PROCEDURE”.

• Are any DTCs present?

Yes

Go to the applicable DTC inspection.

No

DTC troubleshooting completed.