P0387 Ford Crankshaft Position Sensor B Circuit Low Input

P0387 Ford Crankshaft Position Sensor B Circuit Low Input

Possible causes
– Faulty crankshaft position sensor
– Crankshaft position sensor harness is open or shorted
– Crankshaft position sensor circuit poor electrical connection
– Signal plate may be damage
– Starter motor may be faulty
– Starting system circuit
– Dead or weak battery
Tech description
Sometimes and in some models, low battery voltage or a weak starter can can trigger a Crankshaft Position Sensor code. Before replacing any parts, recharge or replaced battery.
What about the obd code?
The crankshaft position sensor (POS) signal is sent to the Electronic Control Module (ECM) during the first few seconds of engine cranking is too low
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
– Lack/Loss of Power
– Engine Stall
P0387 Ford Description

The Crankshaft position sensor also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. This information is used by the Electronic Control Module (ECM) to control ignition and fuel injection. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.

When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.

Ford Vehicle:Ford Escape,Ford Focus Flexifuel,Ford Mustang,Ford Fusion,Ford Taurus,Ford F-Series,Ford Explorer,Ford C-Max,Ford Escape,Ford Edge,Ford Explorer,Ford Flex,Ford Expedition,Ford Transit Connect,Ford F1-50,Ford E-Series Wagon,Ford Super Duty,Ford Fusion Hybrid SE,Ford C-MAX Hybrid SEL,Ford C-MAX Energi,Ford Fusion Energi SE,Ford Fucos Electric,Ford E-Series Van,Ford E-Series Cutaway,Ford Super Duty Pick Up,Ford Chassis Cab,Ford F-650/F-750,Ford Stripped Chassis
CategoriesUncategorized