P1233 Ford Fuel Pump Driver Module Off Line
Possible causes
Also for Mustang:
Tech description
The PCM expects to see one of the following duty cycle signals from the FPDM on the FPM circuit: 1) 50% (500 ms on, 500 ms off), all OK. 2) 25% (250 ms on, 750 ms off), FPDM did not receive a fuel pump (FP) duty cycle command from the PCM, or the duty cycle that was received was invalid. 3) 75% (750 ms ON, 250 OFF), the FPDM has detected a fault in the circuits between the FPDM and the fuel pump.
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
P1233 Ford Description
LS6/LS8 and Thunderbird:
For LS and Thunderbird, this DTC indicates the PCM is not receiving the fuel level information on the communication link from the rear electronics module (REM). REFER to Workshop Manual Section 418 for REM self-test/diagnostics. All Others:
The PCM monitors the fuel pump monitor (FPM) circuit from the fuel pump driver module (FPDM). With the key on, the FPDM continuously sends a duty cycle signal to the PCM through the FPM circuit. The test fails if the PCM stops receiving the duty cycle signal.
Ford Vehicle:Ford Escape,Ford Focus Flexifuel,Ford Mustang,Ford Fusion,Ford Taurus,Ford F-Series,Ford Explorer,Ford C-Max,Ford Escape,Ford Edge,Ford Explorer,Ford Flex,Ford Expedition,Ford Transit Connect,Ford F1-50,Ford E-Series Wagon,Ford Super Duty,Ford Fusion Hybrid SE,Ford C-MAX Hybrid SEL,Ford C-MAX Energi,Ford Fusion Energi SE,Ford Fucos Electric,Ford E-Series Van,Ford E-Series Cutaway,Ford Super Duty Pick Up,Ford Chassis Cab,Ford F-650/F-750,Ford Stripped Chassis