B2416 · نشرات الشركة المصنعة

NISSAN · 2023-05-11

AUTOMATIC BACK DOOR PARTIALLY OPENS IF YOU CONFIRM The automatic back door will only open partially and then will change to “manual mode” when using the Intelligent Key, back door request button, or the interior dash button, OR Any one or combination of the DTCs listed below are stored in AUTO BACK DOOR ECU. ï‚· U2154-87 CAN Comm Circuit ï‚· B2417-15 Touch Sensor Circuit LH Open ï‚· B2416-15 Touch Sensor Circuit RH Open ï‚· B2426-25 Spindle Sensor LH ï‚· B2427-11 Spindle Sensor RH ï‚· B2437-13 Spindle Motor RH ACTION Replace the Automatic Back Door Control Unit.

NISSAN · 2023-05-11

AUTOMATIC BACK DOOR DOES NOT OPEN IF YOU CONFIRM The automatic back door will not open when using the Intelligent Key, back door request button, or the interior dash button, OR Any one or combination of the DTCs listed below are stored in AUTO BACK DOOR ECU. ï‚· U2369-87 CAN Comm Circuit ï‚· U2169-87 CAN Comm Circuit ï‚· B2417-15 Touch Sensor Circuit LH Open ï‚· B2416-15 Touch Sensor Circuit RH Open ï‚· B2426-11 Spindle Sensor LH ï‚· B2436-19 Spindle Motor LH ï‚· B2437-19 Spindle Motor RH ACTION Replace the Automatic Back Door Control Unit.

INFINITI · 2023-05-11

AUTOMATIC BACK DOOR PARTIALLY OPENS IF YOU CONFIRM The automatic back door will only open partially and then will change to “manual mode” when using the Intelligent Key, back door request button, or the interior dash button, OR Any one or combination of the DTCs listed below are stored in AUTO BACK DOOR ECU. ï‚· U2154-87 CAN Comm Circuit ï‚· B2417-15 Touch Sensor Circuit LH Open ï‚· B2416-15 Touch Sensor Circuit RH Open ï‚· B2426-25 Spindle Sensor LH ï‚· B2427-11 Spindle Sensor RH ï‚· B2437-13 Spindle Motor RH ACTION Replace the Automatic Back Door Control Unit.

NISSAN · 2016-03-22

IF YOU CONFIRM The automatic back door does not operate and/or one or a combination of the following DTCs are found stored in the Automatic Back Door Control Module (ABD CU): - B2426-29 (SPINDLE SENSOR LH) - B2427-29 (SPINDLE SENSOR RH) - B2416-1E (TOUCH SEN R OPEN) - B2417-1E (TOUCH SEN L OPEN) - B242A-13 (CLSR CONDITION) ACTION 1. Check the battery voltage (engine not running). - Make sure battery voltage is between 12 and 15.5 volts. - Charge or replace the battery as needed. 2. For 2015 Murano Only: Refer to page 9, step 13 in the Service Procedure to confirm if ABD CU reprogramming is needed. - Reprogram the ABD CU, if needed. - If the ABD CU is reprogramed, also perform Automatic Back Door Manual Configuration. 3. Perform Automatic Back Door Calibration (see page 22). 4. Erase all…