P062F · نشرات الشركة المصنعة

SUBARU · 2025-08-07

This bulletin announces the availability of reprogramming files for the Engine Control Module (ECM) to address the following Diagnostic Trouble Code (DTC): P062F - Internal Control Module EEPROM Error.

SUBARU · 2025-07-14

This bulletin announces the availability of reprogramming files for the Engine Control Module (ECM). This logic was developed to address the following Diagnostic Trouble Code (DTC): P062F - Internal Control Module EEPROM Error.

SUBARU · 2025-05-29

This bulletin announces the availability of reprogramming files for the Engine Control Module (ECM). This logic was developed to address the following Diagnostic Trouble Code (DTC): P062F - Internal Control Module EEPROM Error. If DTC P062F is detected by the ECM, perform the reprogramming procedure outlined in this bulletin.

AUDI · 2025-04-02

This TSB states to follow GFF in instances when DTC P0ED02 is logged then check the diagnostic address for DTCs P0A1F00, P060400, P062F00, P060600, P061000, P151A00.

SUBARU · 2025-03-17

This bulletin announces the availability of reprogramming files for the Engine Control Module (ECM). This logic was developed to address the following Diagnostic Trouble Code (DTC): P062F - Internal Control Module EEPROM Error.

CHEVROLET, GMC · 2024-04-16

This service bulletin provides a service procedure to correct a customer concern of the Malfunction Indicator Lamp (MIL) Illuminated - DTC P062F, P040B, P041B, P0422, P060C, P062B, P1428, P142A, P20EE, P20FE, P22F9, P244A, and/or P244B Set.

FORD · 2023-04-07

Some 2022-2023 F-150 Lightning vehicles may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTCs) U3012, P062F, and/or P0A7F in the battery energy control module (BECM) and/or P0887 in the secondary on-board diagnostic control module-B (SOBDMB) or secondary on-board control module-C (SOBDMC). This may be due to a loose 12 volt positive or negative battery cable connection or loose ground connection. Prior to performing Workshop Manual (WSM) diagnostics, inspect both ends of the positive and negative battery cable connections and tighten if loose. Inspect connector C1168B and ground G127 for loose connections and tighten to 25 Nm (18 lb-ft). Refer to the Wiring Diagram for connector and ground locations. Perform the High Voltage Battery Capacity…

NISSAN · 2023-03-21

MIL ON WITH P062F-00 STORED IN THE ECM IF YOU CONFIRM DTC P062F-00 (CONTROL MODULE) is stored in the ECM, AND No drivability issues are present. ACTION 1. Confirm the current ECM part number. 2. Reprogram the ECM, if applicable.

NISSAN · 2023-01-06

MIL ON WITH DTC P062F-00 STORED IN THE ECM IF YOU CONFIRM The MIL is ON with DTC P062F-00 (Internal Control Module EEPROM Error) stored in the ECM. ACTION 1. Confirm the current ECM part number. 2. Reprogram the ECM, if applicable.

FORD · 2022-09-22

Some 2022 F-150 Lightning vehicles may exhibit an illuminated malfunction indicator (wrench) lamp and/or malfunction indicator lamp (MIL) with diagnostic trouble code(s) (DTCs) U3012, P062F, and/or P0A7F in the battery energy control module (BECM) and/or P0887 in the secondary on-board diagnostic control module-B (SOBDMB), secondary on-board control module-C (SOBDMC). This may be due to a loose 12 volt positive or negative battery cable connection. Prior to performing Workshop Manual (WSM) diagnostics, inspect both ends of the positive and negative battery cable connections and tighten if loose. If the cable is tight, continue with normal workshop manual diagnostics. Be sure to use the Ford Diagnosis and Repair System (FDRS) high voltage battery capacity relearn. This routine must be…

FORD · 2022-02-24

Some 2021 Mustang Mach-E vehicles may exhibit an illuminated powertrain malfunction (wrench) indicator and/or a malfunction indicator lamp (MIL) with diagnostic trouble codes (DTC) P0A7F and/or P062F in the battery energy control module (BECM). This may be due to the BECM software. To correct the condition, follow the Service Procedure to reprogram various modules starting with the powertrain control module (PCM) and perform BECM High Voltage Battery Capacity Relearn.

NISSAN · 2021-04-01

MIL ON WITH DTC P062F AND/OR P0603 STORED IF YOU CONFIRM The MIL is ON and DTC P062F (EEPROM) and/or P0603 (ECM BACK UP/CIRCUIT) is stored, And The customer stated the vehicle was recently started after sitting for an extended period of time (i.e., the battery voltage was low while attempting to start the engine). ACTION 1. Test the vehicle’s 12 volt battery using the Midtronics DSS-5000. Recharge or replace the battery if necessary. 2. Erase all DTCs.

INFINITI · 2021-04-01

MIL ON WITH DTC P062F AND/OR P0603 STORED IF YOU CONFIRM The MIL is ON and DTC P062F (EEPROM) and/or P0603 (ECM BACK UP/CIRCUIT) is stored, And The customer stated the vehicle was recently started after sitting for an extended period of time (i.e., the battery voltage was low while attempting to start the engine). ACTION 1. Test the vehicle’s 12 volt battery using the Midtronics DSS-5000. Recharge or replace the battery if necessary. 2. Erase all DTCs.

CADILLAC, CHEVROLET, GMC · 2018-11-02

This Preliminary information communicates to the dealer an issue where the vehicle's service engine soon light may illuminate due to trouble codes P0601-P0604, P0606, P062B, P062F, P0630, P16F3, or P262B . The dealer is to inspect the engine control module's electrical connections and for proper powers and grounds. Dealer instructed to replace the Engine Control Module, if no other issues found.

JAGUAR · 2017-09-12

Situation: The engine Malfunction Indicator Lamp (MIL) may be illuminated and the message 'restricted performance' may be displayed on the Instrument Cluster (IC). Upon further diagnosis, Diagnostic Trouble Code (DTC) P062F is stored in the Powertrain Control Module (PCM).

JAGUAR · 2017-07-27

Situation: A 'Restricted Performance' message may be displayed in the Instrument Cluster (IC). Upon further investigation, Diagnostic Trouble Code (DTC) P062F-44 may be stored in the Powertrain Control Module (PCM).

JAGUAR · 2017-01-30

Issue: JLR are investigating X260/X760/X761 INGENIUM I4 2.0L Diesel Powertrain control module (PCM) logging DTC P062F- 44 - EEPROM Error.

BUICK, CADILLAC, CHEVROLET, GMC, HUMMER, PONTIAC, SAAB, SATURN · 2015-02-24

This informational bulletin communicates Information to technicians on control module Diagnostic Trouble Code(s) (DTC)(s) P0601, P0602, P0603, P0604, P0606, P062F, P06F3, P1621 which can be shared in multiple modules.

BUICK, CADILLAC, CHEVROLET, GMC, HUMMER, PONTIAC, SATURN · 2014-06-03

This Preliminary Information communication provides information to the technician about vehicle that have a Malfunction Indicator Lamp on. Technician may find Diagnostic Trouble Codes P0601, P0603, P0604, P062F or P1621 stored in the Transmission Control Module. Technician will need to ensure that the Diagnostic Trouble Codes are set in the Transmission Control Module. If the Diagnostic Trouble Codes are only set in the Transmission Control Module reprogram the Transmission Control Module.

NISSAN · 2013-05-30

IF YOU CONFIRM: The Malfunction Indicator Light (MIL) is "ON" with DTC P062F (Internal Control Module EEPROM Error) stored in the Transmission Control Module (TCM). and " No drivability symptoms are present. ACTION: 1. Refer to step 6 in the SERVICE PROCEDURE to confirm this bulletin applies to the vehicle you are working on. 2. If this bulletin applies, reprogram the TCM. See this bulletin for further detail.

BUICK, CHEVROLET · 2013-04-18

This Preliminary Information communication provides information to the technician about vehicles that have the 12V Battery is discharged with a Service Charging System Message, a Malfunction Indicator Lamp and Red Battery Light on. Technician may find Diagnostic Trouble Codes P0A8F and P062F. Technician will need to duplicate the concern. Technician will need to check Make certain that the plastic flashing of the fuse block is not preventing the fuse to fully seat against the bar in the Fuse Block and the nut is fully seated against the fuse, the fuse nut is properly torqued to specification 4.7 newton meter, test for battery voltage on each side of the fuse, test the voltage drop of each fuse, and make sure the Accessory Power Module cable connections and cable crimps at the Starter…

CHEVROLET, GMC · 2011-06-01

BUICK/CHEVROLET/HUMMER/GMC/PONTIAC/CADILLAC/SATURN: TECHNICIANS MAY FIND DTCS P0601, P0603, P0604, P062F OR P1621 STORED IN THE TCM AS AN ACTIVE OR A HISTORY CODE. SOME OF THESE DTCS CAN ALSO BE SET IN THE ECM OR FPCM. MAKE SURE THAT YOU KNOW WHICH MODULE (FOR EXAMPLE ECM, FPCM OR TCM) HAS SET THE DTC BEFORE ATTEMPTING TO DIAGNOSE AND REPAIR THIS CONDITION. *PE UPDATED 8/1/11. *PE