Skip to content

CHRYSLER

08-108-26 REV. A

2026-05-27 · NHTSA 11033327

A listed vehicle is a research lead. Confirm the engine, production range and software in the manufacturer's information.

Manufacturer summary

Original wording in English

Flash: Hybrid Control Processor (HCP) / Auxiliary Hybrid Control Processor (AHCP) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● P0E15-00 - Hybrid-EV Battery Pack Coolant Heater A Control Performance. ● P0A44 - Drive Motor A Position Sensor 1 Circuit Overspeed. ● U0111-00 - Lost Communication With Battery Energy Control Module (BPCM). ● P1625-00 - Park Pawl System Failure. ● U0412-00 - Invalid Data Received From Battery Energy Control Module-A. ● P215B-00 - Vehicle Speed Output Shaft Speed Correlation. ● P079A-00 - Transmission Friction Element 1 Slip Detected. ● P079B-00 - Transmission Friction Element 2 Slip Detected. ● P084F-00 - Park-Neutral Switch Output Customers may also comment on one or more of the following: ● Vehicle does not start / engine does not crank. ● Extended engine cranking time when starting the vehicle. ● Engine turns on when requesting cabin heat to turn on. ● Loss of heat from the engine. ● Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states. ● Vehicle will not start when it is cold (-30°C / -22°F and below). ● Heard and/or felt bump when the gas engine turns on while driving. ● Service Charging System and Traction Battery Cutoff warning messages appear during a key cycle event at -7° C (+20°F). ● Vehicle will force to Park when keyed off in Neutral if the door is open during wake-up procedure and remains open or within 2 minutes of door closure ● Loss of power steering assist when ignition push-button is pressed by driver after a Remote Start. ● Unusual battery drain when DTC, P084F-00 - Park-Neutral Switch Output is set. This software release includes the following software enhancements: ● Corrections to allow the vehicle to clear the permanent fault codes. ● 12V battery overcharged prevention. ● Corrected fuel consumption counter while in charge depleting This bulletin involves reprogramming the **HCP and then the AHCP** with the latest available software.

NHTSA manufacturer communications ↗

Repeated filings are grouped only when make, bulletin number, publication date and complete summary agree. Original record numbers are retained. Older publications remain available, and an explicit later version is shown when established. Pre-1994 vehicle associations are separated from default results; an unspecified year does not mean all model years apply.