Category: OBDii Chassis Codes

C1146 Side G Sensor Circuit Possible causes – Faulty Yaw Rate/Side G Sensor– Yaw Rate/Side G Sensor harness is open or shorted– Yaw Rate/Side G Sensor circuit poor electrical connection What about the obd code? Side G sensor is malfunctioning, or circuit of side G sensor is open or shorted. Symptoms – SLIP Warning Light…

C1148 Speed Wheel Sensor RF Coherency Fault

C1149 Hydraulic Fluid Pressure/ Flow Circuit Failure

C1150 Two Speed Rear Axle Input Switch Circuit Short to Vbatt

C1134 Gear Shift position short to ground

C1135 Gear Shift position short to battery

C1136 Gear Select position short to ground

C1137 ECU is Defective

C1125 Rear Left Output ABS Solenoid What about the obd code? Circuit of rear Left Output ABS solenoid is open or shorted, or control line is open or shorted to power supply or ground.

C1126 Rear Right Input ABS Solenoid What about the obd code? Circuit of rear Right Input ABS solenoid is open or shorted, or control line is open or shorted to power supply or ground.

C1127 Rear Right Output ABS Solenoid What about the obd code? Circuit of rear Right Output ABS solenoid is open or shorted, or control line is open or shorted to power supply or ground.

C1130 Engine Signal 1 What about the obd code? Based on the signal from Engine Control Module (ECM), the Control Area Network (CAN)-Local Arear Network (LAN) converter (CLC) judges that the engine control system is malfunctioning.

C1131 Electric Throttle Control Abnormal. Symptoms – ABS Light ON (or VDC Warning Light)

C1132 ECM CAN Communication Abnormal Symptoms – ABS Light ON (or VDC Warning Light)

C1133 Clutch position ckt short to battery

C1114 ABS Power Relay Output Short Circuit To Ground

C1115 Abnormal Signal What about the obd code? Wheel sensor input is abnormal.

C1116 Stop Lamp Switch What about the obd code? Stop lamp switch circuit is open.

C1117 RPM Input Circuit Failure

C1120 Front Left Input ABS Solenoid What about the obd code? Circuit of front Left Input ABS solenoid is open or shorted, or control line is open or shorted to power supply or ground.