NISSAN · 2015-09-25
IF YOU CONFIRM: An APPLIED VEHICLE has one or both of the following: * Hesitation during acceleration * MIL ON with DTC P0705 (Transmission Range Sensor A Circuit (PRNDL Input)) stored ACTION: 1. Inspect both rear tail lamp assemblies forwater intrusion (see page 2 for sample pictures). 2. If water intrusion is detected, inspect the circuit board of the tail lamp bulb holder(s) for corrosion (see page 2 for sample pictures). 3. If corrosion is found, replace the incident tail lamp assembly(ies). * Refer to the Electronic Service Manual (ESM), section EXL-Exterior Lighting System, for tail lamp replacement. * See PARTS INFORMATION on page 3. NOTE: * Replace only the tail lamp assembly where water intrusion has been detected. * Do NOT replace the CVT assembly for this incident, if it should…