Skip to content

P0E32 · Manufacturer communications

A listed vehicle is a research lead. Confirm the engine, production range and software in the manufacturer's information.

P0E32 ← What does this code mean?

3 Results

LI54.10-P-075043 ↗

MERCEDES-BENZ, MERCEDES-MAYBACH · 2022-07-18

Complaint On affected hybrid vehicles of model series 223, a sporadic or continuously displayed red 12V warning message is shown in the instrument cluster. Cause Based on the current status of the analyses, 2 different causes may be considered probable: ·Failure of the current limiter module: The fault does not necessarily trigger a fault code. This fault profile is likely in the event of continuous 12V red messages. ·A second cause of the fault is indicated by the saved fault codes P0E32FA in the HV DC/DC converter (N82/2; see XENTRY Diagnosis for fault code) and, in some cases, B161609 in the electronic ignition switch (N73). This fault profile is likely in the event of sporadic 12V red messages. Remedy For cause analysis, the quick test for the vehicle should be examined for the…

0803721 ↗

RAM · 2021-03-16

Flash: Hybrid Control Processor (HCP) Updates This bulletin involves updating the HCP with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find one or more of the following Diagnostic Trouble Codes (DTCs). P1A26-00 - BPCM Hybrid Battery State Of Charge Performance. P0A7E-00 - Hybrid/EV Battery Pack Over Temperature. U1003-00 - ESP Can C Bus Performance. P2534-00 - Ignition Switch Run/Start Position Circuit Low. P0506 - Idle Speed Performance Lower Than Expected. P0507 - Idle Speed Performance Higher Than Expected. One Trip DTC Changed to a Two Trip DTC.P0AC6-00 - Hybrid/Ev Battery Temperature Sensor 2 Circuit Performance. P0ACB-00 - Hybrid/Ev Battery Temperature Sensor 3 Circuit…

08-037-21 ↗

RAM · 2021-03-16

Flash: Hybrid Control Processor (HCP) Updates This bulletin involves updating the HCP with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find one or more of the following Diagnostic Trouble Codes (DTCs). P1A26-00 - BPCM Hybrid Battery State Of Charge Performance. P0A7E-00 - Hybrid/EV Battery Pack Over Temperature. U1003-00 - ESP Can C Bus Performance. P2534-00 - Ignition Switch Run/Start Position Circuit Low. P0506 - Idle Speed Performance Lower Than Expected. P0507 - Idle Speed Performance Higher Than Expected. One Trip DTC Changed to a Two Trip DTC.P0AC6-00 - Hybrid/Ev Battery Temperature Sensor 2 Circuit Performance. P0ACB-00 - Hybrid/Ev Battery Temperature Sensor 3 Circuit…