P130D · Manufacturer communications

FORD · 2026-03-06

Some 2023-2024 Bronco Sport vehicles equipped with a 1.5L engine may exhibit an illuminated powertrain malfunction (wrench) indicator with diagnostic trouble code (DTC) P130D stored in the PCM. This may be caused by poor quality fuel being used in the vehicle. As stated in the Owner's Manual under FUEL QUALITY - Choosing the Right Fuel, use of any fuel for which the vehicle was not designed can impair the emission control system, cause loss of vehicle performance, and cause damage to the engine. Do not use: diesel fuel, fuels containing kerosene or paraffin, fuel containing more than 15% ethanol or E85 fuel, fuels containing methanol, fuels containing metallic-based additives, including manganese-based compound, fuels containing the octane booster additive, methylcyclopentadienyl…

FORD · 2026-02-02

Some 2023-2024 Bronco Sport vehicles equipped with a 1.5L engine may exhibit an illuminated powertrain malfunction (wrench) indicator with diagnostic trouble code (DTC) P130D stored in the PCM. Engineering is aware of this condition and is currently working on a solution that is expected in late Q2 of 2026. If a vehicle comes in for this condition, submit a Global Concern Report (GCR) and monitor Professional Technician System (PTS) for additional information and schedule service appointments for customers once the repair becomes available.

FORD · 2021-12-10

Some 2020-2021 Escape and 2021 Bronco Sport vehicles equipped with a 1.5L EcoBoost engine may experience a lack of power, excessive spark knock and an illuminated malfunction indicator lamp (MIL) and/or a powertrain malfunction (wrench) indicator with diagnostic trouble code (DTC) P130D stored in the powertrain control module (PCM). This concern typically occurs under moderate to high load conditions at highway speeds. This may be due to a loose ground at G109 or G107. To correct this condition, inspect G109 for the ground eyelet being installed upside down/loose/corrosion and G107 ignition coil ground. The eyelet on G109 has a tab that should be facing down to stop rotation during tightening.

FORD · 2021-02-23

Some 2019-2020 F-150 vehicles equipped with a 2.7L EcoBoost engine built on or before 04-Jul-2020 may experience an illuminated malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P2196, P2198, P2BF0, P2BF2, P2BF1, P2BF3, P2BEC, P2CEE, P2BED, P130D and/or P2BEF stored in the powertrain control module (PCM). There may also be an intermittent brief deceleration when cruise control is enabled. This may be due to software in the PCM. To correct the condition, follow the Service Procedure to reprogram the PCM.

FORD, LINCOLN · 2020-12-18

Some 2020 Explorer/Aviator vehicles equipped with a 2.3L/3.0L EcoBoost engine may exhibit an illuminated malfunction indicator lamp (MIL) and/or Engine Coolant Over Temperature warning with diagnostic trouble codes (DTCs) P0116, P0117, P0118, P0119, P0128, P0217, P0330, P1026, P1299, and/or P130D. This may be due to the engine coolant temperature (ECT) sensor or ECT sensor wiring harness. For 2.3L vehicles, replace the ECT sensor and pigtail wiring connector (GU2Z-14S411-KA). For 3.0L vehicles, replace the ECT and knock sensor. To aid with the engineering investigation, do not disconnect the wiring connector from the ECT sensor during disassembly. Leave the connector on the sensor in case parts are called back for analysis.

FORD · 2020-09-18

Some 2018 F-150 vehicles equipped with a 2.7L EcoBoost engine may experience an illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTCs) P2196, P2198, P2BF0, P2BF2, P2BF1, P2BF3, P2BEC, P2BED, P2BEE, P2BEF, P130D, P0300, P0316, P0301-P0306, P0171, P0174, P219A, P219B, P0172 and/or P0175 stored in the powertrain control module (PCM). This may be due to software in the powertrain control module (PCM) or direct injection fuel injectors leaking down. To correct the condition, follow the Service Procedure to reprogram the PCM and/or replace the direct injection fuel injectors.

FORD · 2020-08-10

Some 2019-2020 F-150 vehicles equipped with a 2.7L EcoBoost engine built on or before 04-Jul-2020 may experience an illuminated malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P2196, P2198, P2BF0, P2BF2, P2BF1, P2BF3, P2BEC, P2CEE, P2BED, P130D and/or P2BEF stored in the powertrain control module (PCM). This may be due to software in the PCM. To correct the condtion, follow the Service Procedure to reprogram the PCM.

FORD, LINCOLN · 2020-07-20

Some 2020 Explorer/Aviator vehicles equipped with a 3.0L EcoBoost engine may exhibit an illuminated malfunction indicator lamp (MIL) and/or Engine Coolant Over Temperature warning with diagnostic trouble codes (DTCs) P0116, P0117, P0118, P0119, P0128, P0217, P0330, P1026, P1299, and/or P130D. This may be due to the engine coolant temperature (ECT) sensor or ECT sensor wiring harness. To correct the condition, replace the ECT and knock sensor. To aid with the engineering investigation, do not disconnect the wiring connector from the ECT sensor during disassembly. Leave the connector on the sensor in case parts are called back for analysis.

FORD, LINCOLN · 2020-07-10

Some 2015-2020 F150/Edge/Fusion, 2016-2018 MKX, 2019-2020 Nautilus, and 2017-2020 Continental vehicles equipped with 2.7L EcoBoost engines may exhibit an illuminated malfunction indicator lamp (MIL) and/or Engine Coolant Over Temperature warning with diagnostic trouble codes (DTCs) P0116, P0117, P0118, P0119, P0128, P0217, P0330, P1026, P1299, and/or P130D. This may be due to the engine coolant temperature (ECT) sensor or knock sensor wiring harness. To correct the condition, replace the 12A648 ECT sensor and 12A699 knock sensor. Do not disconnect the ECT sensor from the knock sensor harness in case parts are called back for analysis. For claiming, use causal part 12A699 and applicable labor operations in Section 10 of the Service Labor Time Standards (SLTS) Manual.

FORD, LINCOLN · 2019-02-06

Some 2015-2019 F150/Edge, 2016-2018 MKX, 2019 Nautilus and 2017-2019 Fusion/Continental vehicles equipped with a 2.7L engine may exhibit a malfunction indicator lamp (MIL) and/or wrench lamp with diagnostic trouble codes (DTCs) P0116, P0117, P0118, P0119, P0217, P0330, P1026, and/or P130D. This may be due to a engine coolant temperature (ECT) sensor connector which is not fully seated or damaged wiring between connectors C1064 and C1047 for F150 and C1016 and C1168 for Edge/MKX/Nautilus/Fusion/Continental vehicles. ECT sensors should not be replaced if damaged wiring is found at or near these connectors. For claiming, use causal part 12A699 and applicable labor operations in Section 10 of the Service Labor Time Standards (SLTS) Manual.

FORD, LINCOLN · 2017-11-08

Some 2015-2018 F150/Edge, 2016-2018 MKX and 2017-2018 Fusion, Continental vehicles equipped with a 2.7L engine may experience a malfunction indicator lamp (MIL) and/or wrench lamp with Diagnostic Trouble Codes (DTCs): P0116, P0117, P0118, P0119, P0217, P0330, P1026, and/or P130D. This may be due to a engine coolant temperature (ECT) sensor connector which is not fully seated or damaged wiring between connectors C1064 and C1047 for F150 and C1016 and C1168 for Edge/MKX/Fusion/Continental vehicles. ECT sensors should not be replaced if damaged wiring is found at or near these connectors. If an issue with the wiring is found use causal part 12A699.

FORD · 2016-09-21

Some 2016-2017 Transit vehicles equipped with a 3.5L GTDI engine and built on or before 13-Sep-2016 may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P130D and no related performance concern. An occasional spark knock noise may be noticed with this condition. Follow the Service Procedure steps to correct the condition.

FORD · 2016-08-11

SOME 2016 TRANSIT VEHICLES EQUIPPED WITH A 3.5L GTDI ENGINE MAY EXHIBIT AN ILLUMINATED MIL WITH DIAGNOSTIC TROUBLE CODE (DTC) P130D AND NO RELATED PERFORMANCE CONCERN. AN OCCASIONAL SPARK KNOCK NOISE MAY BE NOTICED WITH THIS CONDITION. ENGINEERING IS CURRENTLY INVESTIGATING. KNOCK SENSOR REPLACEMENT WILL NOT CORRECT THIS CONCERN. CLEAR THE DTC AND RETURN VEHICLE TO THE CUSTOMER. TO ASSIST WITH THE INVESTIGATION USE THE REPORT A VEHICLE CONCERN LINK AT THE BOTTOM OF THE OASIS REPORT TO SUBMIT A GLOBAL CONCERN REPORT (GCR). CONTINUE TO MONITOR OASIS FOR UPDATES.