C1115 · Herstellerinformationen

AUDI · 2016-02-26

Side assist inoperative or warning about sensor vision. Audi side assist (lane change assist) does not work. A warning about sensor vision appears in the driver information system. DTCs B200000, C111504, C1114F3, or C1115F5 may be stored in the lane change assistance control module. Defective internal control unit component. Production Solution is improved hardware.

CHEVROLET, GMC · 2015-07-30

This Preliminary Information communication provides information to the technician for a service trailer brake message on in the vehicle. The technician will find diagnostic trouble codes C1115, C1116, C1117, or C1118. In most cases the chassis control module is not the cause of the trouble codes. The technician should inspect the wiring between the chassis control module and the trailer brake control switch. The inline connectors X185 or X138 as well as the connectors X1 and X5 of the X61A junction block should be thoroughly inspected looking for backed out, loose, poor retention or any other terminal issues. If there are no wiring concerns are found the trailer brake control switch is most likely the cause.

AUDI · 2015-03-25

Supersedes Technical Service Bulletin Group 96 number 13-51 dated February 15, 2013. Audi side assist deactivates immediately after the engine is started. DTC C1115F2 (Lane change assistance control module 2 Function limitation due to insufficient voltage) is logged in the lane change assistance control module. The software of the lane change assistance control module, J769 (3C), has been optimized to remove this condition.

AUDI · 2013-12-05

Lane Change Assistant "Sensors Blocked" warning in DIS (DTC C1114F3 and C1115F5)

AUDI · 2013-09-23

Lane Change Assistant "Sensors Blocked" warning in DIS (DTC C1114F3 and C1115F5)

AUDI · 2013-02-15

Supersedes Technical Service Bulletin Group 96 number 13-49 dated February 1, 2013. Audi Side Assist deactivates itself immediately after the engine starts. DTC C1115F2 (Lane change assistance control module 2 Function limitation due to insufficient voltage) is logged in the lane change assistance control module, J769 (3C). The lane change assistance control module, J769 (3C), checks voltage after each engine on cycle. During this check, the voltage can be incorrectly reported which causes the DTC to set.

CHEVROLET, GMC · 2010-06-01

CHEVROLET/GMC: SERVICE TRAILER BRAKE MESSAGE WITH DTC(S) C1115, C1116, C1117, AND/OR C1118 (INSPECT WIRING NEAR PARKING BRAKE PEDAL). THIS CONCERN MAY BE VERY INTERMITTENT AND CAN OCCUR WITH OR WITHOUT A TRAILER CONNECTED TO TRUCK. *PE

FORD · 2000-03-01

SOME VEHICLES EQUIPPED WITH REAR ANTI-LOCK BRAKES MAY EXHIBIT DIAGNOSTIC TROUBLE CODES C1113 / C1115 / C1185. *TT

FORD · 2000-03-01

SOME VEHICLES EQUIPPED WITH REAR ANTI-LOCK BRAKES MAY EXHIBIT DIAGNOSTIC TROUBLE CODES C1113 / C1115 / C1185. *TT

FORD · 1999-05-01

VEHICLES EQUIPPED WITH REAR WHEEL ANTI-LOCK BRAKES MAY EXHIBIT AN ABS LAMP ON AND DIAGNOSTIC TROUBLE CODE C1115. *TT

FORD · 1999-05-01

SOME VEHICLES MAY EXHIBIT AN ANTI-LOCK BRAKE SYSTEM (ABS) LAMP ON AND DIAGNOSTIC TROUBLE CODE (DTC) C1115). *TT