C1142 · Herstellerinformationen

NISSAN · 2022-09-29

DTC C1116 AND/OR C1142 STORED IN THE ABS CONTROL MODULE IF YOU CONFIRM Customer states the ABS warning light is ON and “System fault See Owner’s Manual” appears in the message center (Figure 1), AND DTCs C1116 (Stop Lamp Switch) and/or C1142 (Press Sen Circuit) are stored in the ABS Control Module. ACTION Follow the SERVICE PROCEDURE in this bulletin to: 1. Install the Center High Mount Stop Lamp (CHMSL) Relay and Jumper Harness. 2. Install a new Stop Lamp Switch. 3. Reprogram the ABS Control Module. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.

NISSAN · 2022-03-15

SERVICE INFORMATION FOR BRAKE SWITCH ADJUSTMENT FOR DTC C1142 AND/OR C1116 STORED SERVICE INFORMATION DTC C1142 (PRESS SEN CIRCUIT) and/or C1116 (STOP LAMP SW) may be stored if the Stop Lamp Switch and/or the Brake Pedal Position Switch are out of adjustment. Before replacing any components for DTCs C1142 (PRESS SEN CIRCUIT) and/or C1116 (STOP LAMP SW), stored as past or current, confirm that the Stop Lamp Switch and the Brake Pedal Position Switch are properly adjusted. If either the Stop Lamp Switch and/or the Brake Pedal Position Switch are found to be out of adjustment, adjust them as per the ESM, and then clear the DTCs and perform DTC confirmation. ï‚· Refer to the ESM: BRAKES > BRAKE SYSTEM > PERIODIC MAINTENANCE > BRAKE PEDAL > Adjustment

INFINITI · 2022-03-15

SERVICE INFORMATION FOR BRAKE SWITCH ADJUSTMENT FOR DTC C1142 AND/OR C1116 STORED SERVICE INFORMATION DTC C1142 (PRESS SEN CIRCUIT) and/or C1116 (STOP LAMP SW) may be stored if the Stop Lamp Switch and/or the Brake Pedal Position Switch are out of adjustment. Before replacing any components for DTCs C1142 (PRESS SEN CIRCUIT) and/or C1116 (STOP LAMP SW), stored as past or current, confirm that the Stop Lamp Switch and the Brake Pedal Position Switch are properly adjusted. If either the Stop Lamp Switch and/or the Brake Pedal Position Switch are found to be out of adjustment, adjust them as per the ESM, and then clear the DTCs and perform DTC confirmation. ï‚· Refer to the ESM: BRAKES > BRAKE SYSTEM > PERIODIC MAINTENANCE > BRAKE PEDAL > Adjustment

NISSAN · 2020-09-16

2017-2019 ARMADA; ENGINE DOES NOT CRANK IF YOU CONFIRM The engine will not crank and will not start, but the battery test result is OK, OR One of these DTCs are stored: ï‚· C1142 (PRESS SENSOR) ï‚· C1A04 (ABS/TCS/VDC SYSTEM) ï‚· C1A26 (ECD MODE MALFUNCTION) AND The color of the stop lamp switch is solid black, as shown in Figure 1. ACTION Replace the stop lamp switch.

MAZDA · 2007-02-08

ABS WARNING LIGHT ON WITH DTC C1141, C1142, C1233, OR C1234/GRINDING NOISE FROM THE FRONT WHEELS. *KB

FORD · 1996-10-18

INFORMATION ON ABS DTC C1141 OR C1142. *TT