B1471 · Comunicaciones del fabricante

LINCOLN · 2024-01-12

Some 2022-2023 Navigator vehicles may exhibit diagnostic trouble code (DTC) B1471:13 setting in the seat control module - G (SCMG) and/or seat control module - H (SCMH) after module reprogramming or replacement. This may be due to the module configuration. To correct the condition, perform the SCMG - Driver Multi-Contour Seat Module (SCMG) and/or SCMH - Passenger Multi-Contour Seat Module (SCMH) Configuration application on the module storing the DTC using the latest level of the Ford Diagnosis and Repair System (FDRS). For claiming, use causal part 14F548 and applicable labor operations in Section 10 of the Service Labor Time Standards (SLTS) Manual.

FORD, LINCOLN · 2019-12-20

Some 2015-2019 F-150, 2015-2020 Explorer, 2017-2019 F-Super Duty, 2017-2020 Continental, 2018-2020 Expedition/Navigator, 2016-2018 MKX, 2019-2020 Nautilus, 2020 Aviator/Corsair and 2013-2020 MKZ vehicles equipped with multi-contour seats may exhibit intermittent multi-contour seat operation and/or massage and lumbar adjust inoperative from the seat switch or SYNC screen with or without diagnostic trouble code (DTC) B1471, U024B, and/or U024C. This may be due to terminal fretting at the connector for the driver multi-contour seat module (SCMG) and passenger multi-contour seat module (SCMH). To correct the condition, follow the Service Procedure steps to replace the connectors and reroute the harness.

FORD, LINCOLN · 2019-09-27

Some 2015-2019 F-150/Explorer, 2017-2019 F-Super Duty/Continental, 2018-2019 Expedition/Navigator, 2016-2018 MKX, 2019 Nautilus, and 2013-2019 MKZ vehicles equipped with Multi-Contour seats may exhibit intermittent multi-contour seat operation and/or massage and lumbar adjust inoperative from the seat switch or SYNC screen with or without diagnostic trouble code (DTC) B1471, U024B, and/or U024C. This may be due to terminal fretting at the connector for the driver multi-contour seat module (SCMG) and passenger multi-contour seat module (SCMH). To correct the condition, follow the Service Procedure steps to replace the connectors and reroute the harness.