P0AFB · Comunicaciones del fabricante

MERCEDES-BENZ, MERCEDES-MAYBACH · 2026-02-09

Complaint Model Year 2019-2022 167 (GLE/GLS) - Instrument Cluster Message for Suspension "Do Not Drive Over 50MPH" with or without Illumination of Check Engine Light with DTC's C10159A (A108/2, A108/3) and P0AFB00 (N129) Cause PTCU software robustness. Remedy Check N127 - PTCU (Powertrain Control Unit) hardware and software numbers. If software number matches a "Hardware Number" and "Predecessor Software #", update software. If software number is not shown in "Predecessor Software #" and condition exists, open a TIPS case to the High Voltage/ Low Voltage inbox.

MERCEDES-BENZ · 2024-09-20

Complaint Engine does not restart from ECO start. Hybrid system malfunction (Gears symbol) in instrument cluster. Fault codes below may be stored in ISA control unit. P0A44B2- Drive motor "A" Position Sensor Circuit Overspeed. The speed is below the threshold value. P0AFB00- The power supply of high voltage on-board electrical system is too high. Cause Reduced current output to ISA during ECO start. Remedy If additional faults are stored for 48V system components, process these first. Update software of ISA control unit. New software numbers - A2569022304 A2569033903

TOYOTA · 2022-07-28

TT: Mil On. DTC P0AFB11 (Hybrid/EV Battery Current Sensor "A" Circuit Short to Ground), P0ABF15 (Hybrid/EV Battery Current Sensor "A" Circuit Short to Auxiliary Battery or Open), P0ABF28 (Hybrid/EV Battery Current Sensor "A" Signal Bias Level Out of Range / Zero Adjustment Failure), P0AA649 (Hybrid/EV Battery Voltage System Isolation Internal Electronic Failure) or P33CF49 ( Hybrid/EV Battery Voltage System Isolation Internal Electronic Failure Abnormal Area Detection Failure) present for HV Battery Current Sensor/Battery ECU

SATURN · 2019-02-08

This Preliminary Information communication provides information to the technician On rare occasions, an intermittent loss of IPC gauges may be encountered, and the SES and Battery Lights may illuminate. Additionally, a no crank concern may be encountered once the vehicle is turned off unless a battery charger is connected to the 12 volt battery. During diagnosis, DTCs P0AF8 and/or P0AFB will be stored. In most instances, both DTCs will be stored together. This may be the result of a poor connection at the negative hybrid battery cable. If a poor connection exists, the 12 volt battery may discharge enough to cause this concern. If the vehicle is operated like this long enough, a no crank may occur because there may not be enough 12 volt system voltage present for the SGCM to energize the…