RAM

18-031-25 REV. B

2025-09-27 · NHTSA 11023602

掲載車両は調査の手がかりです。エンジン、製造期間、ソフトウェア条件はメーカー資料で確認してください。

メーカー概要

英語の原文

Flash: Powertrain Control Module (PCM) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● **P00C6-00 - Fuel Rail Pressure Too Low - Engine Cranking - in ACTIVE or STORED status. ● P0325-00 - Knock/Combustion Vibration Sensor 1 Circuit - in ACTIVE or STORED status. ● P0330-00 - Knock/Combustion Vibration Sensor 2 Circuit - in ACTIVE or STORED status. ● P032A-00 - Knock-Combustion Vibration Sensor C Circuit - in ACTIVE or STORED status. ● P018B-00 - Fuel Pressure Sensor "B" Circuit Range/performance - in ACTIVE or STORED status. ● P2AF6-00 - Starter Relay 3 Stuck Off - in ACTIVE or STORED status. ● P0300-00 - Multiple Cylinder Misfire - in ACTIVE or STORED status set during cold start catalyst heating. ● P0301-00 - Cylinder 1 Misfire - in ACTIVE or STORED status set during cold start catalyst heating. ● P0302-00 - Cylinder 2 Misfire - in ACTIVE or STORED status set during cold start catalyst heating. ● P0303-00 - Cylinder 3 Misfire - in ACTIVE or STORED status set during cold start catalyst heating. ● P0304-00 - Cylinder 4 Misfire - in ACTIVE or STORED status set during cold start catalyst heating. ● P0305-00 - Cylinder 5 Misfire - in ACTIVE or STORED status set during cold start catalyst heating. ● P0306-00 - Cylinder 6 Misfire - in ACTIVE or STORED status set during cold start catalyst heating. NOTE: To confirm the cold start catalyst heating, use WiTech Freeze Frame data, and confirm "Time Since Engine Start" less than 30 seconds and "Engine Coolant Temperature °F" less than 122°F (50°C) when Misfire Code was set. See Step 3 for more details. ● U0104-00 - Lost Communication With Cruise Control Module - in ACTIVE or STORED status. This software flash will allow these permanent fault codes to naturally clear. ● U0405-00 - Invalid Data Received From Cruise Control Module - in ACTIVE or STORED status. This software flash will allow these permanent fault codes to naturally clear.** Customers may experience the following: ● A potential to stall when coming to a stop with an immediate restart. If the engine were to stall while stopping, a message would display in the Instrument Panel Cluster (IPC) informing the driver to shift to park to restart the engine This bulletin involves inspecting and possibly reprogramming the PCM with the latest available software.

メーカー、番号、発行日、全文概要が一致した登録だけをまとめ、元番号を残します。古い資料も保持し、明示的に確認できた後続版を表示します。1994年以前の車両との関連は通常結果から分離します。年式未記載は全年式への適用を意味しません。