FREIGHTLINER, MERCEDES-BENZ

LI09.41-N-080666

2026-06-03 · NHTSA 11034415

掲載車両は調査の手がかりです。エンジン、製造期間、ソフトウェア条件はメーカー資料で確認してください。

メーカー概要

英語の原文

Check engine light with reduced power –P300A6D due to charge air system contamination Complaint The check engine light is activated, accompanied by fault code 'P300A6D The boost pressure is too low', indicating reduced boost pressure. Cause Charge air system restriction due to contamination: • Oil mist from the crankcase ventilation system can enter the intake tract and deposit within the charge air system • Under high thermal load and with soot-laden or aged engine oil, these deposits may carbonize • Carbonized deposits can loosen and accumulate in the charge air cooler and related components • This can result in partial or complete restriction of the charge air cooler, leading to underboost conditions and fault codes such as P300A6D Contributing factors may include: • High engine load operating profiles • Extended oil service intervals or degraded engine oil condition Remedy Prerequisite: Complete all guided diagnostic test steps for fault code P300A6D in Xentry Diagnostics and follow LI09.40-N-079144 before performing the repairs below. If carbonized oil deposits or restriction are identified within the charge air system: 1. Replace the following components as a set: • Charge air cooler • Exhaust turbocharger • Charge air pipe upstream of the charge air cooler 2. After completing repairs: • Perform engine oil and filter replacement using an approved specification oil. Approved oil specifications: • MB 229.52 SAE 5W-30 - BB00.40-P-0229-52A • MB 229.51 SAE 5W-30 - BB00.40-P-0229-51A 3. Perform control unit adaptations: • Reset intake air system adaptation values • Reset low-pressure exhaust gas recirculation (EGR) adaptation values 4. After repair completion: • Perform a test drive • Verify that the fault code does not return 5. If the vehicle is within warranty and the charge air cooler is determined to be obstructed by debris, use damage code 50301 B2 when submitting the warranty claim. Notes: • Additional component replacement is not required unless supported by further diagnostic results. • Do not replace the charge air distributor pipe or Clean Air Line unless additional faults (for example, air mass-related faults) are present. • After replacement of components, ensure proper initialization and learning procedures are completed in the control unit. • Creation of an XENTRY TIPS case is not required for this condition. • Please review the attached photos for previously identified causes of these fault codes.

メーカー、番号、発行日、全文概要が一致した登録だけをまとめ、元番号を残します。古い資料も保持し、明示的に確認できた後続版を表示します。1994年以前の車両との関連は通常結果から分離します。年式未記載は全年式への適用を意味しません。