HINO · 2022-04-14
SB-22-007 2020MY CONVENTIONAL DTC P0005 AND/OR P20DE, P24A1, P24A2
P0005 · メーカー技術情報
掲載車両は調査の手がかりです。エンジン、製造期間、ソフトウェア条件はメーカー資料で確認してください。
P0005 ← このコードの意味は？5 検索結果
HINO · 2020-07-23
20MY Conventional trucks equipped with a bubbler filter 23304-EV460 may set Diagnostic Trouble Codes (DTC's) P20DE and/or P0005 under some conditions. If a truck comes into your location exhibiting these DTC's and is equipped with the 23304-EV460 bubbler filter, replace the filter with 23304-EV023 and retest.
HINO · 2016-08-02
Engine - COE Trucks (155, 155h, 195, or 195h) An enhanced fuel cut valve is available to address a potential sticking coindition that results in excess residual pressure in the dosing injector (7th injector) supply pipe. A stickingf fuel cut valve may result in the following DTC'S (Diagnostic trouble codes) setting. P0005/P20DE/P20DF In Engine ECU.
HINO · 2016-08-02
SB-16-020 An enhanced fuel cut valve is available to address a potential sticking condition that results in excess residual pressure in the dosing injector (7thinjector) supply pipe. A sticking fuel cut valve may result in the following DTC?s (diagnostic trouble codes) setting: 1. If DTC P0005 (fuel cut valve stuck closed) sets in the engine ECU, replace the fuel cut valve with the part number listed below. 2. If DTC P20DE (pressure sensor performance invalid) or DTC P20DF (pressure sensor signal too low) set in the engine ECU, this could be a result of the fuel cut valve sticking. Follow the workshop manual diagnostic procedure in section 4 of the Hino Workshop Manual (J05E Engine Control System) for the DTC. Also, inspect for signs of fuel contamination that could restrict the fuel…
HINO · 2016-08-02
SB-16-019 An enhanced fuel cut valve is available to address a potential sticking condition that results in excess residual pressure in the dosing injector (7thinjector) supply pipe. A sticking fuel cut valve may result in the following DTC?s (diagnostic trouble codes) setting: 1. If DTC P0005 (fuel cut valve stuck closed) sets in the engine ECU, replace the fuel cut valve with the part number listed below. 2. If DTC P20DE (pressure sensor performance invalid) or DTC P20DF (pressure sensor signal too low) set in the engine ECU, this could be a result of the fuel cut valve sticking. Follow the workshop manual diagnostic procedure in section 4 of the Hino Workshop Manual (J08E Engine Control System) for the DTC. Also, inspect for signs of fuel contamination that could restrict the fuel…