P013B · メーカー技術情報

JEEP · 2026-06-16

Flash: Powertrain Control Module (PCM) Updates - PCR8A3 Technicians may find one or more of the following Diagnostic Trouble Code (DTC): SYMPTOM: ● **P22D3-00 - Turbo Turbine Inlet Valve Stuck Closed. DTC falsely sets. ● P016A-00 - Excessive Time To Enter Closed Loop Air/fuel Ratio Control. DTC falsely sets.** ● P04B6-00 - Fuel Fill Door Stuck Closed (Stored Status). NOTE: There will be no Malfunction Indicator Lamp (MIL) for this DTC. Customers may also experience one or more of the following: ● The vehicle will not start and cannot be keyed off. NOTE: The vehicles 12V system remains powered up. ● Poor combustion stability or "wavy" engine RPM oscillations during engine warm-ups. ● Engine Stop/Start (ESS) bumps or lack of refinement. ● Noisy/poor starts in extreme cold temperatures. ●…

JEEP · 2026-05-12

Flash: Powertrain Control Module (PCM) Updates - PCR8A3 Technicians may find the following Diagnostic Trouble Code (DTC): ● P04B6-00 - Fuel Fill Door Stuck Closed (Stored Status). NOTE: There will be no Malfunction Indicator Lamp (MIL) for this DTC. Customers may also experience one or more of the following: ● The vehicle will not start and cannot be keyed off. NOTE: The vehicles 12V system remains powered up. ● Poor combustion stability or "wavy" engine RPM oscillations during engine warm-ups. ● Engine Stop/Start (ESS) bumps or lack of refinement. ● Noisy/poor starts in extreme cold temperatures. ● Perceived after-run pump noise after vehicle is turned off. The following software enhancements are also available: ● Diagnostic improvements for DTCs, P013A-00, P013B-00, P013E-00 and…

AUDI · 2020-07-08

This bulletin contains a software update that addresses DTC P013B00 and/or P013A00.

AUDI · 2020-06-08

This bulletin contains a softwre updaet that addresses DTC P013B00 and/or P013A00.

AUDI · 2020-05-19

This bulletin contains a softwre updaet that addresses DTC P013B00 and/or P013A00.

AUDI · 2019-10-11

This informational bulletin contains instructions for when DTC P013B00 and DTC P013A00 are stored with the MIL on for a PSS.

CHEVROLET, GMC · 2015-03-10

This preliminary informational bulletin provides diagnostic tips for a customer concern of Malfunction Indicator Lamp (MIL) intermittently illuminated, and technicians finding DTCs P013B, P013D, P167E, P0171 or P0174 set.

DODGE · 2014-08-01

Malfunction Indicator Lamp Illumination Due To Oxygen Sensor This bulletin involves the installation of an Oxygen (O2) Sensor Overlay Harness for any Oxygen Sensor related DTC(s). The Overlay Harness will consist of twelve 18 AWG wires (six from each Oxygen Sensor) that run to a new Oxygen Sensor Module connector. Four wires will be removed from the original vehicle O2 Module connector and installed in the new overlay harness O2 Module connector.Do NOT replace any parts prior to performing this bulletin and the Verifications test below. If the vehicle has any of the following DTC?s for O2 Sensors, Stored, Pending or Active, perform the Repair Procedure. P013A O2 Sensor 1/2 Slow Response - Rich To Lean (Soot related code, see note). P013B O2 Sensor 1/2 Slow Response - Lean To Rich (Soot…

CHEVROLET, GMC · 2013-07-16

This Preliminary Information communication provides information to the technician about vehicles that have Diagnostic Trouble Code P2270 set with Diagnostic Trouble Codes P0140, P0139, P0138, P0137, P013A, and P013B. Technician should inspect for a bent terminal on the X131 connector.

CHEVROLET, GMC · 2013-06-10

This Preliminary Information communication provides information to the technician about vehicles that have Diagnostic Trouble Code P2270 set with Diagnostic Trouble Codes P0140, P0139, P0138, P0137, P013A, and P013B. Technician should inspect for a bent terminal on the X131 connector.

CHEVROLET, GMC · 2013-05-24

This Preliminary Information communication provides information to the technician about vehicles that have Diagnostic Trouble Code P2270 set with Diagnostic Trouble Codes P0140, P0139, P0138, P0137, P013A, and P013B. Technician should inspect for a bent terminal on the X131 connector.

DODGE · 2013-03-01

Malfunction Indicator Lamp Illumination Due To Oxygen Sensor inspecting for the part number of the transmission harness and based on the part number suffix, determining if the Oxygen Sensor Module Connector requires repair. Some model year 2011 harness' were built with tin plated terminals in 5 of the connector cavities that should have been gold plated. Based on the transmission harness part number, the terminals will be replaced as required.Service Bulletin's 25-004-12 and 18-012-12 REV. A (or later bulletins) must also be performed (if not previously performed). If the vehicle has any of the following DTC?s for O2 Sensors, Stored, Pending or Active, perform the Repair Procedure BEFORE replacing any parts. P013A O2 Sensor 1/2 Slow Response - Rich To Lean (Soot related code, see note)…

DODGE · 2013-03-01

Malfunction Indicator Lamp Illumination Due To Oxygen Sensor inspecting for the part number of the transmission harness and based on the part number suffix, determining if the Oxygen Sensor Module Connector requires repair. Some model year 2011 harness' were built with tin plated terminals in 5 of the connector cavities that should have been gold plated. Based on the transmission harness part number, the terminals will be replaced as required. Service Bulletin's 25-004-12 and 18-012-12 REV. A (or later bulletins) must also be performed (if not previously performed). If the vehicle has any of the following DTC?s for O2 Sensors, Stored, Pending or Active, perform the Repair Procedure BEFORE replacing any parts. P013A O2 Sensor 1/2 Slow Response - Rich To Lean (Soot related code, see note)…

DODGE · 2013-03-01

Malfunction Indicator Lamp Illumination Due To Oxygen Sensor inspecting for the part number of the transmission harness and based on the part number suffix, determining if the Oxygen Sensor Module Connector requires repair. Some model year 2011 harness' were built with tin plated terminals in 5 of the connector cavities that should have been gold plated. Based on the transmission harness part number, the terminals will be replaced as required.Service Bulletin's 25-004-12 and 18-012-12 REV. A (or later bulletins) must also be performed (if not previously performed). If the vehicle has any of the following DTC?s for O2 Sensors, Stored, Pending or Active, perform the Repair Procedure BEFORE replacing any parts. P013A O2 Sensor 1/2 Slow Response - Rich To Lean (Soot related code, see note)…

DODGE · 2012-12-18

Malfunction Indicator Lamp Illumination Due To Oxygen Sensor This bulletin involves replacement of the Oxygen Sensor Connectors for any Oxygen Sensor related DTC. Do NOT replace any parts prior to performing this bulletin and the Verifications test below. If the vehicle has any of the following DTC?s for O2 Sensors, Stored, Pending or Active, perform the Repair Procedure. ? P013A O2 Sensor 1/2 Slow Response - Rich To Lean (Soot related code, see note) ? P013B O2 Sensor 1/2 Slow Response - Lean To Rich (Soot related code, see note) ? P014C O2 Sensor 1/1 Slow Response - Rich To Lean (Soot related code, see note) ? P014D O2 Sensor 1/1 Slow Response - Lean To Rich (Soot related code, see note) ? P0030 O2 Sensor 1/1 Heater Circuit ? P0031 O2 Sensor 1/1 Heater Circuit Low ? P0032 O2 Sensor 1/1…

DODGE · 2012-12-18

Malfunction Indicator Lamp Illumination Due To Oxygen Sensor This bulletin involves replacement of the Oxygen Sensor Connectors for any Oxygen Sensor related DTC. Do NOT replace any parts prior to performing this bulletin and the Verifications test below. If the vehicle has any of the following DTC?s for O2 Sensors, Stored, Pending or Active, perform the Repair Procedure.? P013A O2 Sensor 1/2 Slow Response - Rich To Lean (Soot related code, see note)? P013B O2 Sensor 1/2 Slow Response - Lean To Rich (Soot related code, see note) ? P014C O2 Sensor 1/1 Slow Response - Rich To Lean (Soot related code, see note) ? P014D O2 Sensor 1/1 Slow Response - Lean To Rich (Soot related code, see note) ? P0030 O2 Sensor 1/1 Heater Circuit ? P0031 O2 Sensor 1/1 Heater Circuit Low ? P0032 O2 Sensor 1/1…

VOLKSWAGEN · 2010-06-02

VOLKSWAGEN: IMPROVED ECM SOFTWARE CALIBRATION TO STABILIZE 02 SENSOR DIAGNOSIS. 02 SENSOR DIAGNOSIS TOO SENSITIVE AND CONTAMINATION OF THE 02 SENSOR CAUSING MIL ON WITH DTCS P0136, P0139, P2271, P013B AND/OR P320C. *PE

CHEVROLET, GMC, HUMMER, SAAB · 2008-06-01

GMC: INTERMITTENT SES LIGHT DUE TO DTCS P013B AND/OR P0411 DTC. *PE