表示

P016A · メーカー技術情報

掲載車両は調査の手がかりです。エンジン、製造期間、ソフトウェア条件はメーカー資料で確認してください。

P016A ← このコードの意味は?

11 検索結果

18-052-26 REV. A ↗

JEEP · 2026-06-16

Flash: Powertrain Control Module (PCM) Updates - PCR8A3 Technicians may find one or more of the following Diagnostic Trouble Code (DTC): SYMPTOM: ● **P22D3-00 - Turbo Turbine Inlet Valve Stuck Closed. DTC falsely sets. ● P016A-00 - Excessive Time To Enter Closed Loop Air/fuel Ratio Control. DTC falsely sets.** ● P04B6-00 - Fuel Fill Door Stuck Closed (Stored Status). NOTE: There will be no Malfunction Indicator Lamp (MIL) for this DTC. Customers may also experience one or more of the following: ● The vehicle will not start and cannot be keyed off. NOTE: The vehicles 12V system remains powered up. ● Poor combustion stability or "wavy" engine RPM oscillations during engine warm-ups. ● Engine Stop/Start (ESS) bumps or lack of refinement. ● Noisy/poor starts in extreme cold temperatures. ●…

18-019-15 REV C ↗

RAM · 2015-12-02

Flash: 3.0L Powertrain Diagnostic And System Enhancements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. A small number of customers may experience bucking under hard acceleration. In addition other customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation a technician may find one of more of the following Diagnostic Trouble Codes (DTCs) set in the PCM memory: ? P1296-00 - EGR Slow Response - Increasing Flow. ? P249C-00 - Excessive Time To Enter Closed Loop Reductant Injection Timing Control. ? P20C2-00 - Reductant Heater 3 Control Circuit Performance. ? P24A4-00 - Particulate Filter Restriction - Soot Accumulation Too High. ? P24D1-00 - Particulate Matter Sensor Regeneration…

18-019-15 REV-B ↗

RAM · 2015-08-25

Flash: 3.0L Powertrain Diagnostic And System Enhancements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation a technician may find one of more of the following Diagnostic Trouble Codes (DTCs) set in the PCM memory. ? P2196-00 ? O2 Sensor 1/1 Stuck Rich. ? P1E0C-00 ? Empty Fuel Tank. ? P2237-00 ? O2 Sensor 1/1 Pump Cell Current Circuit Open. ? P1297-00 ? EGR Slow Response - Decreasing Flow. ? P0420-00 ? Catalyst Efficiency (Bank 1). ? P24AF-00 ? Particulate Matter Sensor Circuit Performance. ? P26AB ? Engine Coolant Bypass Valve Stuck. ? P204F-00 ? Reductant System Performance. ? P20E9-00 ? Reductant Pressure Too…

18-019-15 REVA ↗

RAM · 2015-06-02

Flash: 3.0L Powertrain Diagnostic And System Enhancements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation a technician may find one of more of the following Diagnostic Trouble Codes (DTCs) set in the PCM memory. ? P204F-00 Reductant System Performance. ? P20E9-00 Reductant Pressure Too High. ? P249C-00 Excessive Time To Enter Closed Loop Reductant Injection Control. ? P2002-00 Diesel Particulate Filter Efficiency Below Threshold. ? P20C2-00 Reductant Heater 3 Control Circuit Performance. ? P2299-00- Brake Pedal Position/Accelerator Pedal Position Incompatible. ? P208B-00 Reductant Pump 1 Control Performance. ?…

18-021-15 REVA ↗

RAM · 2015-05-27

Flash: 3.0L Powertrain Diagnostic And System Enhancements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. It also involves replacement of the Oxygen (O2) Sensor and cleaning or replacement of the Exhaust Gas Temperature (EGT) Sensor 1/2 if necessary depending on Diagnostic Trouble Codes (DTC) that may have set. A small number of customers may experience an intermittent engine shudder or vibration which may not set a Diagnostic Trouble Code (DTC). In addition other customers may experience a Malfunction Indicator Lamp (MIL) illumination upon which the technician may find one or more of the following DTCs have been set: ? P20C2-00 - Reductant Heater 3 Control Circuit Performance. ? P204F-00 - Reductant System Performance. ?…

18-021-15 ↗

RAM · 2015-03-14

Flash: 3.0L Powertrain Diagnostic And System Enhancements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. It also involves replacement of the Oxygen (O2) Sensor and cleaning or replacement of the Exhaust Gas Temperature (EGT) Sensor 1/2 if necessary depending on Diagnostic Trouble Codes (DTC) that may have set. A small number of customers may experience an intermittent engine shudder or vibration which may not set a Diagnostic Trouble Code (DTC). In addition other customers may experience a Malfunction Indicator Lamp (MIL) illumination upon which the technician may find one or more of the following DTCs have been set: ? P20C2 - Reductant Heater 3 Control Circuit Performance. ? P204F - Reductant System Performance. ? P20E9 -…

18-019-15 ↗

RAM · 2015-03-04

Flash: 3.0L Powertrain Diagnostic And System Enhancements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation a technician may find one of more of the following Diagnostic Trouble Codes (DTCs) set in the PCM memory. ? P20C2 - Reductant Heater 3 Control Circuit Performance. ? P204F - Reductant System Performance. ? P20E9 - Reductant Pressure Too High. ? P016A-00 - Excessive Time To Enter Closed Loop Air/Fuel Ratio Control. In addition to addressing the above DTCs, the following powertrain system improvements/enhancements are also included in this software release. ? Enhancements to improve A/C compressor relay duty…

1807314 ↗

RAM · 2014-12-19

Flash: 3.0L Powertrain Diagnostic And System Enhancements EGR System And AC Compressor Relay Operation This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. The following powertrain system improvements/enhancements are included in this software release. ? Enhancements to improve A/C compressor relay duty cycle operation to prevent ignition off battery draw. ? Powertrain system improvements to enable EGR cleaning routine. ? Software to eliminate Malfunction Indicator Lamp (MIL) Illumination with no defect found for Diagnostic Trouble Code (DTC) P016A-00 - Excessive Time To Enter Closed Loop Air/Fuel Ratio Control.

18-073-14 ↗

RAM · 2014-12-19

Flash: 3.0L Powertrain Diagnostic And System Enhancements EGR System And AC compressor Relay Operation This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. The following powertrain system improvements/enhancements are included in this software release. * Enhancements to improve A/C compressor relay duty cycle operation to prevent ignition off battery draw. * Powertrain system improvements to enable EGR cleaning routine. * Software to eliminate Malfunction Indicator Lamp (MIL) Illumination with no defect found for Diagnostic Trouble Code (DTC) P016A-00 - Excessive Time To Enter Closed Loop Air/Fuel Ratio Control.

1802814REVD ↗

RAM · 2014-12-18

Flash: MIL Illumination - Diagnostic and System Improvements Bulletin involves reprogramming the Powertrain Control Module (PCM) with latest available software. It also involves replacement of the Oxygen (O2) Sensor and cleaning or replacement of Exhaust Gas Temperature (EGT) Sensor 1/2 if necessary, depending on Diagnostic Trouble Codes (DTC) that may have set. A small number of customers may experience an intermittent engine shudder or vibration which may not set a Diagnostic Trouble Code (DTC) other customers may experience a Malfunction Indicator Lamp (MIL) illumination upon which technician may find one or more of following DTCs have been set: P016A-00 - Excessive Time To Enter Closed Loop Air/Fuel Ratio Control. P2459-00 - Diesel Particulate Filter Regeneration Frequency. P0133-00 -…

18-028-14 REV. D ↗

RAM · 2014-12-18

Flash: MIL Illumination - Diagnostic and System Improvements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. It also involves replacement of the Oxygen (O2) Sensor and cleaning or replacement of the Exhaust Gas Temperature (EGT) Sensor 1/2 if necessary depending on Diagnostic Trouble Codes (DTC) that may have set. A small number of customers may experience an intermittent engine shudder or vibration which may not set a Diagnostic Trouble Code (DTC). In addition other customers may experience a Malfunction Indicator Lamp (MIL) illumination upon which the technician may find one or more of the following DTCs have been set: P016A-00 - Excessive Time To Enter Closed Loop Air/Fuel Ratio Control. P2459-00 - Diesel Particulate Filter…