掲載車両は調査の手がかりです。エンジン、製造期間、ソフトウェア条件はメーカー資料で確認してください。
P27B2 ← このコードの意味は？4 検索結果
FORD, LINCOLN · 2025-08-01
Some of the vehicles listed in the Model statement above may exhibit an incorrectly illuminated malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P27B2 stored in the secondary on-board diagnostic control module C (SOBDMC). This may be due to the software in the SOBDMC.
FORD, LINCOLN · 2021-03-03
Some 2020-2021 Explorer/Aviator vehicles equipped with an 10R60 automatic transmission may exhibit diagnostic trouble code (DTC) P27B2 stored in the powertrain control module (PCM) memory. This DTC may be present due to activation of the transmission park by wire manual release during vehicle assembly and has not yet achieved the 40 warm up cycles needed to be cleared from memory. Before attempting a repair for this DTC, clear the DTC and if it returns, refer to the WSM, Section 307-01 for normal diagnostics. For claiming, use causal part 12A650 and applicable labor times in section 10 of the Service Labor Time Standards (SLTS) Manual.
FORD · 2021-01-29
Some 2021 F-150 vehicles equipped with 2.7L, 3.3L, 3.5L and 5.0L engines vehicles may exhibit an illuminated malfunction indicator (MIL) with diagnostic trouble codes (DTC) P0230 and P27B2 stored in the powertrain control module (PCM) while in transport mode. These DTCs can set together if the vehicle is driven over 45mph for greater than 60 seconds while in transport mode. If both DTC P0230 and P27B2 are present, clear the DTCs, and deactivate transport mode per the Workshop Manual (WSM), Section 419-10 > General Procedures. If the DTCs return, refer to the WSM for normal diagnostics. For claiming, use causal part 12A650 and applicable labor times in section 10 of the Service Labor Time Standards (SLTS) Manual.
LINCOLN · 2019-03-18
2018-2019 Navigator, 2019 Nautilus vehicles may exhibit a stuck in park and or no start condition with diagnostic trouble code (DTC) P27B2 stored in the powertrain control module (PCM) or transmission control module (TCM) memory. The condition may occur when the customer exits remote start and selects either REVERSE or DRIVE without first depressing the brake pedal. Disconnect the battery for 2 minutes and clear the DTCs. Advise the customer to first apply and hold the brake pedal before selecting REVERSE or DRIVE after a remote start event. Do not attempt any repairs at this time. Engineering is investigating, monitor OASIS for updates.