JEEP

18-086-24

2024-12-11 · NHTSA 11011903

목록의 차량은 조사 단서입니다. 제조사 자료에서 엔진, 생산 기간, 소프트웨어 조건을 확인하세요.

제조사 요약

영어 원문

"Flash: Powertrain Control Module (PCM) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● **P0325 - Knock/Combustion Vibration Sensor ""A"" Circuit. ● P0330 - Knock/Combustion Vibration Sensor ""B"" Circuit. ● P0300 - Multiple Cylinder Misfire. (NA Market Only) ● P032A - Knock/Combustion Vibration Sensor ""C"" Circuit. ● P018B - Fuel Pressure Sensor ""B"" Circuit Rang/Performance. ● P1CEA - Boost Side EVAP Purge System Performance. (NA Market Only)** ● P00F3 - Humidity Sensor Circuit Range/Performance. ● P06DD - Engine Oil Pressure Control Circuit Performance/Stuck Off. ● P00C6 - Fuel Rail Pressure Too Low - Engine Cranking. Customers may also comment on one or more of the following: ● **Low oil pressure Instrument Cluster Panel (IPC) warning during heavy towing. ● Engine RPM dip below idle speed during coast down to idle.** ● Undesirable vehicle drivability behavior causing a vehicle Shift to Park event during Engine Stop Start (ESS) while Adaptive Cruise Control (ACC) is active. ● Idle speed oscillations observed when in Snow and Mud modes for vehicle configured with 4x2 drivetrain. ● Screen two incorrectly pops up on the IPC for five seconds during Terrain and Rock mode. ● Fully Autonomous Parking Assist (FAPA) is not deactivated when the accelerator pedal is pressed. ● Vehicle is not heating up fast enough at freezing temperatures. **The following software calibration improvements are also available: ● Engine mega knock detection. ● Misfire during cold start. ● Avoid false failures with MIL on. (NA Market Only)** This bulletin involves reprogramming the PCM with the latest available software."

제조사, 번호, 발행일, 전체 요약이 같은 등록만 묶고 원래 번호를 보존합니다. 과거 자료도 유지하며 확인된 명시적 후속판만 표시합니다. 1994년 이전 관계는 기본 결과와 분리합니다. 연식 미기재는 모든 연식 적용이 아닙니다.