MERCEDES-BENZ

LI15.18-P-078654

2024-12-20 · NHTSA 11012059

목록의 차량은 조사 단서입니다. 제조사 자료에서 엔진, 생산 기간, 소프트웨어 조건을 확인하세요.

제조사 요약

영어 원문

Complaint Engine warning light active. Fault code P012D12 The pressure sensor upstream of exhaust gas turbocharger has short circuit to positive. There is a short circuit to positive. is stored in the control unit N3/10 N3/10 - engine electronics 'MED41''M264'. Cause In the course of a pre-repair, the lines may be damaged due to the feed line to component part B28/11 pressure sensor downstream of air filter being routed too taut. (see picture 1) Remedy 1. Attach 12 V charger Note: An adequate voltage from the on-board electrical system battery must be guaranteed for the entire duration of the work procedure. Otherwise the control units could be damaged if an undervoltage occurs. Information: Observe the operating instructions of the 12 V charger. Information: Use the 12 V charger to ensure a sufficient voltage (minimum 12.5 V) from the on-board electrical system battery. -------------------------------------------------------------------------------------------------------------------------------- 2. Attach diagnostic system Information: Always ensure that XENTRY Diagnosis is updated to the latest version. For further information on "Retail Data Storage", see the Service Information bulletin SI00.01-D-0044SG. Information: The operation steps in XENTRY Diagnosis must be complied with precisely at all times. -------------------------------------------------------------------------------------------------------------------------------- 3. Carry out quick test and read out fault memory Information: If the above-mentioned fault code (P012D12) is stored in the control unit ME (N3/10) continue with operation step 4. -------------------------------------------------------------------------------------------------------------------------------- 4. Check line installation of component part B28/11 pressure sensor downstream of air filter for damage and routing free of tension. Repair defective lines as per XENTRY WIS. Note: Routing of the feed line free of tension must be ensured. (See picture 2)

제조사, 번호, 발행일, 전체 요약이 같은 등록만 묶고 원래 번호를 보존합니다. 과거 자료도 유지하며 확인된 명시적 후속판만 표시합니다. 1994년 이전 관계는 기본 결과와 분리합니다. 연식 미기재는 모든 연식 적용이 아닙니다.