MERCEDES-BENZ

LI72.40-P-065822

2025-01-24 · NHTSA 11013307

목록의 차량은 조사 단서입니다. 제조사 자료에서 엔진, 생산 기간, 소프트웨어 조건을 확인하세요.

제조사 요약

영어 원문

Complaint - Power window reverses direction on reaching upper end position. - Power window inoperative, fault code P060A64 / B18C12A / B192015 is stored in fault memory of door control unit. Cause - Software error in door control unit (N69/X). - Power window motor(s) on front door, left (M10/3) and/or front door, right (M10/4) => On vehicles with CODE 808, 809 or 800. Remedy 1.) Read out hardware version of affected door control unit (N69/X) using quick test (see Figure 1). => For door control units with hardware version equal to/higher than 16/20 (year/week), continue with operation step 2. => For door control units with hardware versions 13/49, 14/23, 14/24 and 14/30, continue with operation step 3. 2.) Replace affected power window motor (M10/X). IMPORTANT NOTE (see also SI document under WIS reference): For vehicles with CODE 808, 809 or 800, the only motors in stock are the new power window motors with modified carbon brushes for the front doors. For this reason, when replacing the power window motor left front door (M10/3) or the front right power window motor, it is also essential to adapt the power window parameters in the corresponding control unit, front door, left (N69/1) or control unit, front door, right (N69/2). When doing so, the following procedure must be followed: a) Replace power window motor(s) on front door, left (M10/3) and/or right (M10/4). b) Carry out commissioning of the door control unit(s) for the front door, left (N69/1) and/or right (N69/2) using Xentry Diagnostics. c) Then perform a function test on the power window system by operating the power window switch in the direction of "AUTOMATIC DOWN" and "AUTOMATIC UP"to fully open and close the side window. Note: Only replace the power window motor if the door control unit hardware version is 16/20! 3.) Perform commissioning of affected door control unit. (Path: Xentry Diagnostics => Control units view => DCU-XX (N69/X) => Adaptations => Commission) Note: Since 09.08.2018, a new SCN coding is available for the current software release! Commissioning ensures that the door control unit receives the current software release and the new SCN coding.

제조사, 번호, 발행일, 전체 요약이 같은 등록만 묶고 원래 번호를 보존합니다. 과거 자료도 유지하며 확인된 명시적 후속판만 표시합니다. 1994년 이전 관계는 기본 결과와 분리합니다. 연식 미기재는 모든 연식 적용이 아닙니다.