JEEP

9100840

2026-07-15 · NHTSA 11035192

목록의 차량은 조사 단서입니다. 제조사 자료에서 엔진, 생산 기간, 소프트웨어 조건을 확인하세요.

제조사 요약

영어 원문

Switchbank 4 gang The customer will notice either one or two of the following conditions: 1. Fuel Door is Not opening when Fuel door Switch is pushed. Technician Observe the DTC P04CB-FUEL FILL DOOR OPEN REQUEST SENSOR-SWITCH CIRCUIT HIGH. 2. Drives Modes do not work when Switch is pressed (Hybrid, Electric, E-save). Technician Observe DTC U113B-LOST COMMUNICATION WITH SWITCH BANK MODULE. Procedure: If during vehicle Scan diagnostics besides DTC's P04CA, P04CB or U113B. there are another DTCs Repair it First accordingly. DTC's may be related to main ECU's like: HCP, BCM, PCM, etc. If DTC P04CB and/or U113B are still present, then follow the following action before replacing the Switch: 1. Read vehicle DTCs while the IGN ON. 2. Verify ESBM feed fuse state. Replace the fuse if needed. 3. Wiggle the ESBM harness takeout (LIN and ESBM feed takeout) and monitor the state of DTC P04CB and/or U113B. o If this step affects DTC P04CB and/or U113B. behavior, the issue is likely related to a failure in the harness. 4. Disconnect the harness from the ESBM and confirm there not any damage, like bend PINs, corrosion, etc. 5. Confirm Harness continuity. 6. Verify power to ESBM by back probing the ESBM connector o If voltage is lower than 11.8V, follow normal procedures for low batteries. - If there no damage in the harness nor the connector and pins of the ESBM, reconnect it ensuring the harness connector is being fully engaged into the ESBM connector. 7. Confirm Continuity of the harness from the ESBM connector to the BCM connectors. 8. Reconnect the ESBM and then Verify LIN bus activity with Mopar scope. o Config scope to LIN monitor if feasible. o Replace the ESBM only based confirmation from the LIN diagnostic. 9. With the scan tool, read DTCs. If still DTC are set, replace ESBM (Fuel door and drive modes Switch module) in accordance with the Service Information. Flag the part to be returned to supplier for further part analysis.

제조사, 번호, 발행일, 전체 요약이 같은 등록만 묶고 원래 번호를 보존합니다. 과거 자료도 유지하며 확인된 명시적 후속판만 표시합니다. 1994년 이전 관계는 기본 결과와 분리합니다. 연식 미기재는 모든 연식 적용이 아닙니다.