보기

B127B · 제조사 기술 자료

목록의 차량은 조사 단서입니다. 제조사 자료에서 엔진, 생산 기간, 소프트웨어 조건을 확인하세요.

B127B ← 이 코드는 무엇을 뜻하나요?

5 결과

PIT5405C ↗

CADILLAC, CHEVROLET, GMC · 2017-01-27

This Preliminary Information communication provides information to the technician about vehicles that have a reduced or loss of power steering assist, steering wheel jerks or kicks back when turning, Service Stabilitrak message with warning chime, engine stall, Instrument Panel Cluster going blank or inoperative, radio/Integrated Center Stack going blank, Heater-Vent-Air Conditioning going blank, hood ajar message and/or dome lamps flash when shifting into reverse, alarm sounds when locking doors or door locks cycling, and or wipers continue to run for a short time after turning off and then stop/park in the incorrect location. Technician may find Diagnostic Trouble Codes U0073, U0078, U0029, U0028, U0415, U0140, U0126, U0121, U0101, U0100, C0544, C0710, U1510, B127B, B2605, B3600, C0800,…

PIT5405B ↗

CADILLAC, CHEVROLET, GMC · 2016-08-17

THIS PRELIMINARY INFORMATION COMMUNICATION PROVIDES INFORMATION TO THE TECHNICIAN FOR A REDUCED POWER MESSAGE, STEERING ASSIST, ENGINE STALL OR THE INSTRUMENT PANEL, RADIO, AND OR HEATER-VENT-AIR CONDITIONING GO BLANK WITH MULTIPLE DIAGNOSTIC TROUBLE CODES. IF ANY OF THE FOLLOWING DIAGNOSTIC TROUBLE CODES U0073, U0078, U0029, U0028, U0415, U0140, U0126, U0121, U0101, U0100, C0544, U1510, U0073, B127B, B2605, B3600,C0800, U0428, AND U0452 SET IN THE VEHICLE. CHECK THE BODY CONTROL MODULE GROUND AT THE G218 LOCATION. THE FRONT DASH INSULATOR MAT MAY BE TRAPPED BETWEEN THE GROUND EYELET AND THE BODY STUD. REMOVE THE ROUND NUT AND EYELET AND CUT THE FRONT DASH INSULATOR MAT AWAY FROM THE GROUND STUD SO IT NO LONGER INTERFERES WITH THE GROUND STUD AND REINSTALL THE EYELET AND GROUND NUT.…

PIT5366 ↗

CADILLAC · 2016-02-03

This Preliminary Information communication provides information to the technician about vehicles that may have a rear camera or radio inoperative. Technician may find a Diagnostic Trouble Code B127B sym 2B. Technician will need to gain access to the Human Machine Interface and unplug the X1 connector terminal 5 (circuit 5986) and test for 12 volts with the ignition mode switch in the ON position. When there is no voltage found on terminal 5 (circuit 5986) inspect X205 for possible terminal damage on circuit 5986 terminal 19.

PIT5405A ↗

CADILLAC, CHEVROLET, GMC · 2015-11-12

This Preliminary Information communication provides information to the technician for a reduced power message, steering assist, engine stall or the instrument panel, radio, and or Heater-Vent-Air Conditioning go blank with multiple diagnostic trouble codes. If any of the following diagnostic trouble codes U0073, U0078, U0029, U0028, U0415, U0140, U0126, U0121, U0101, U0100, C0544, U1510, U0073, B127B, B2605, B3600,C0800, U0428, and U0452 set in the vehicle. Check the body control module ground at the G218 location. The front dash insulator mat may be trapped between the ground eyelet and the body stud. Remove the round nut and eyelet and cut the front dash insulator mat away from the ground stud so it no longer interferes with the ground stud and reinstall the eyelet and ground nut.

PIT5405 ↗

CADILLAC, CHEVROLET, GMC · 2015-05-04

This Preliminary Information communication provides information to the technician for a reduced power message, steering assist, engine stall or the instrument panel, radio, and or Heater-Vent-Air Conditioning go blank with multiple diagnostic trouble codes. If any of the following diagnostic trouble codes U0073, U0078, U0029, U0028, U0415, U0140, U0126, U0121, U0101, U0100, C0544, U1510, U0073, B127B, B2605, B3600,C0800, U0428, and U0452 set in the vehicle. Check the body control module ground at the G218 location. The front dash insulator mat may be trapped between the ground eyelet and the body stud. Remove the round nut and eyelet and cut the front dash insulator mat away from the ground stud so it no longer interferes with the ground stud and reinstall the eyelet and ground nut.