AUDI · 2020-05-18
This bulletin contains instructions for DTCs P218100, P017B00, P308100, and P01E400.
P2181 · 제조사 기술 자료
목록의 차량은 조사 단서입니다. 제조사 자료에서 엔진, 생산 기간, 소프트웨어 조건을 확인하세요.
P2181 ← 이 코드는 무엇을 뜻하나요?86 결과
AUDI · 2020-04-10
This bulletin contains instructions for DTCs P218100, P017B00, P308100, and P01E400.
AUDI · 2020-03-26
This bulletin contains instructions for DTCs P218100, P017B00, P308100, and P01E400.
AUDI · 2020-03-11
This bulletin contains instructions for DTCs P218100, P017B00, P308100, and P01E400.
AUDI · 2017-11-20
This bulletin contains information regarding a cooling DTC P218100 and proper cooling guidelines.
VOLKSWAGEN · 2016-04-21
MIL-ON, FAULT P309F OR P309D, NO ELECTRIC DRIVE MODE CUSTOMER STATES CRANK NO START AND/OR IN-TANK FUEL PUMP MAKING NOISE AND POSSIBLY WITH FUEL PUMP FAULTS MIL-ON, FAULT P013E IN THE ECM MIL-ON, FAULT P164B IN ECM MIL-ON, FAULT P0011 AND/OR P0016 IN THE ECM MIL-ON, FAULT P2407 IN THE ECM CUSTOMER STATES NOISE FORM THE ENGINE/TURBO CUSTOMER STATES THE FUEL GAUGE DOES NOT READ FULL MIL ON, FAULT P2181 IN THE ECM MIL-ON, FAULT P0456 IN THE ECM CUSTOMER STATES THERE IS A NOISE WHILE TURNING/ GOING OVER BUMPS VEHICLE ALIGNMENT NOT CORRECT, STEERING OFF CENTER, PULLS, DRIFTS, DURING PDI CLUTCH PEDAL SQUEAL/SQUEAK WHEN OPERATING CLUTCH PEDAL CUSTOMER STATES THE A/C SYSTEM DOES NOT PERFORM PROPERLY CUSTOMER STATES INTERIOR "A" PILLAR TRIM IS LOOSE CUSTOMER STATES WIND NOISE FROM DRIVERS…
VOLKSWAGEN · 2016-04-21
MIL-ON, FAULT P309F OR P309D, NO ELECTRIC DRIVE MODE CUSTOMER STATES CRANK NO START AND/OR IN-TANK FUEL PUMP MAKING NOISE AND POSSIBLY WITH FUEL PUMP FAULTS MIL-ON, FAULT P013E IN THE ECM MIL-ON, FAULT P164B IN ECM MIL-ON, FAULT P0011 AND/OR P0016 IN THE ECM MIL-ON, FAULT P2407 IN THE ECM CUSTOMER STATES NOISE FORM THE ENGINE/TURBO CUSTOMER STATES THE FUEL GAUGE DOES NOT READ FULL MIL ON, FAULT P2181 IN THE ECM CUSTOMER STATES THERE IS A NOISE WHILE TURNING/ GOING OVER BUMPS VEHICLE ALIGNMENT NOT CORRECT, STEERING OFF CENTER, PULLS, DRIFTS, DURING PDI CLUTCH PEDAL SQUEAL/SQUEAK WHEN OPERATING CLUTCH PEDAL CUSTOMER STATES THE A/C SYSTEM DOES NOT PERFORM PROPERLY CUSTOMER STATES INTERIOR "A" PILLAR TRIM IS LOOSE CUSTOMER STATES WIND NOISE FROM DRIVERS DOOR/WINDOW GUIDE CUSTOMER STATES…
VOLKSWAGEN · 2016-04-13
MIL-ON, FAULT P309F OR P309D, NO ELECTRIC DRIVE MODE CUSTOMER STATES CRANK NO START AND/OR IN-TANK FUEL PUMP MAKING NOISE AND POSSIBLY WITH FUEL PUMP FAULTS MIL-ON, FAULT P013E IN THE ECM MIL-ON, FAULT P164B IN ECM MIL-ON, FAULT P0011 AND/OR P0016 IN THE ECM MIL-ON, FAULT P0011 AND/OR P0016 IN THE ECM MIL-ON, FAULT P0011 AND/OR P0016 IN THE ECM MIL-ON, FAULT P2407 IN THE ECM CUSTOMER STATES THE FUEL GAUGE DOES NOT READ FULL MIL ON, FAULT P2181 IN THE ECM MIL-ON, FAULT P0456 IN THE ECM CUSTOMER STATES THERE IS A NOISE WHILE TURNING/ GOING OVER BUMPS VEHICLE ALIGNMENT NOT CORRECT, STEERING OFF CENTER, PULLS, DRIFTS, DURING PDI CLUTCH PEDAL SQUEAL/SQUEAK WHEN OPERATING CLUTCH PEDAL CUSTOMER STATES THE A/C SYSTEM DOES NOT PERFORM PROPERLY CUSTOMER STATES WIND NOISE FROM DRIVERS DOOR/WINDOW…
AUDI · 2016-03-31
The MIL is on due to DTC P218100 being stored in the ECM. The coolant temperature gauge does not work, the vehicle does not reach operating temperature, and the cooling fan runs constantly. The coolant temperature control sends an implausible signal. The coolant thermostat does not work.
CHALET, DODGE, RAM · 2015-11-21
Flash: MIL Illumination With Transmission And Driveability Improvements This bulletin involves flash reprogramming the Powertrain Control Module (PCM) with new software. The customer may experience a MIL illumination. Upon further investigation the technician may find that any of the following erroneous Diagnostic Trouble Codes (DTCs): ? U0140 - Lost Communication With Body Control Module. 2010 DJ 5.7L (Sales Code EZC) Attempting to clear this DTC will be unsuccessful. ? P050D - Cold Start Rough Idle. ? P2181 - Cooling System Performance has been set. ? P0935 - Line Pressure Sensor Circuit High. All RFE transmissions. P0300 through P0308 - Multiple and Single Cylinder Misfire. This condition can occur when the vehicle is started cold and the driver immediately places the vehicle in drive…
BUICK, CADILLAC, CHEVROLET · 2015-06-02
This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that engine overheating, and/or poor heater performance, AC off message, and Malfunction Indicator Lamp illumination. Technician will find Diagnostic Trouble Code P00B7 and/or P2181. Technician will gain access to the water outlet assembly and inspect for flashing or debris. If flashing or debris found in the water outlet assembly it will need to be replaced. Also inspect the upper heater core hose and coolant bypass pipe at the water outlet for a black plug. If plug is found, remove and discard.
AUDI · 2015-05-13
Supersedes Technical Service Bulletin Group 01 number 14-88 dated August 15, 2014. The MIL is on. DTC P218100 (Cooling System Performance) is stored in the engine control module (ECM), J623 (address word 01). DTC P218100 will be stored if, after a specified air flow (warm-up phase), the measured engine temperature does not reach the value in the timing map. Particles in the cooling system from the production process affect the closing of the coolant thermostat. Replacing the coolant temperature sender does not fix the problem.
VOLKSWAGEN · 2014-09-03
Update Programming, MIL ON, DTC P2181 Stored in ECM Memory
AUDI · 2014-08-15
DTC P218100 will be stored if, after a specified air flow (warm-up phase), the measured engine temperature does not reach the value in the timing map. Particles in the cooling system from the production process affect the closing of the coolant thermostat.
AUDI · 2014-07-10
If the measured engine temperature does not reach the value in the timing map after a specified air flow, DTC P218100 will be stored.
AUDI · 2014-07-10
Supersedes Technical Service Bulletin Group 01 number 14-70 dated March 10, 2014. The MIL is on. DTC P218100 is stored in the engine control module. If the measured engine temperature does not reach the value in the timing map after a specified air flow, DTC P218100 will be stored.
AUDI · 2014-03-10
If the measured engine temperature does not reach the value in the timing map after a specified air flow, DTC P218100 will be stored.
AUDI · 2014-03-10
The MIL is on. DTC P218100 is stored in the ECM. If the measured engine temperature does not reach the value in the timing map after a specified air flow, DTC P218100 will be stored.
CADILLAC, CHEVROLET · 2013-04-19
This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that engine overheating, and/or poor heater performance, AC off message, and Malfunction Indicator Lamp illumination. Technician will find Diagnostic Trouble Code P00B7 and/or P2181. Technician will gain access to the water outlet assembly and inspect for flashing or debris. If flashing or debris found in the water outlet assembly it will need to be replaced. Also inspect the upper heater core hose and coolant bypass pipe at the water outlet for a black plug. If plug is found, remove and discard.
MITSUBISHI · 2013-02-26
Some affected vehicles may display the MIL (Malfunction Indicator Lamp), with DTC P2181 - Cooling System Performance recorded in PCM memory. This TSB provides a procedure to correct this condition by reprogramming the PCM with new software.
CHEVROLET · 2013-02-18
This Preliminary Information communication provides information to the technician about vehicles that have an engine overheats ?A/C Off? or ?High Engine Temperature? Messages are displayed on the Instrument Panel Cluster poor heater performance after extended idling, or cruising at low revolutions per minute for extended period. Technician may find Diagnostic Trouble Code P00B7 or P2181 may be set in the Engine Control Module. Technician will need to check the water outlet for plastic flashing and/or debris by remove the water outlet attached to the rear of the cylinder head. Technician will need clean or replace the water outlet as needed.
CHEVROLET, PONTIAC · 2012-12-17
This Preliminary Information communication provides information to the technician about vehicles that may have Diagnostic Trouble Code P2181 set. Technician will need to use a Technician 2 and test the engine coolant thermostat heater. If the coolant temperature does not reach 195 Fahrenheit (90 Celsius) within 5 minutes, replace the thermostat. Technician should also check to ensure the calibrations are up to date.
CHEVROLET, GMC · 2012-10-29
This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on shortly after cold start. Technician will find a Diagnostic Trouble Code P2181 in the Engine Control Module. Technician will need to inspect the rear heater pipes shown below for proper installation.
CHEVROLET · 2012-10-17
This Preliminary Information communication provides information to the technician about vehicles that have an engine overheats "A/C Off" or "High Engine Temperature" Messages are displayed on the Instrument Panel Cluster poor heater performance after extended idling, or cruising at low revolutions per minute for extended period. Technician may find Diagnostic Trouble Code P00B7 or P2181 may be set in the Engine Control Module. Technician will need to check the water outlet for plastic flashing and/or debris by remove the water outlet attached to the rear of the cylinder head. Technician will need clean or replace the water outlet as needed.
PORSCHE · 2005-05-09
CHECK ENGINE LIGHT ACTIVATED - DIAGNOSTIC CODE P2181 AND/OR P3081 IN THE DME FAULT MEMORY. *TT
DODGE · 2002-11-29
ENGINE THROTTLE CONTROL LIGHT ILLUMINATION AND / OR MALFUNCTION INDICATOR LIGHT ILLUMINATION WITH DIAGNOSTIC TROUBLE CODE P2181 - COOLING SYSTEM PERFORMANCE. *TT