P0510 Audi Closed Throttle Position Switch Malfunction

P0510 Audi Closed Throttle Position Switch Malfunction

Possible causes
– Throttle Position Switch (TPS) Adjustment
– Faulty Throttle Position Switch (TPS)
– Throttle Position Switch (TPS) harness open or shorted
– Throttle Position Switch (TPS) circuit poor electrical connection
Tech description
Adjusting the Throttle Position Switch (TPS) may take care of the problem, if the problem persist the TPS may need to be replaced.
What about the obd code?
Malfunction is detected when battery voltage from the closed throttle position switch is sent to ECM with the throttle valve opened.
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
– Engine idle problems
– Possible hard to start
– Possible shifting problems
P0510 Audi Description

A closed Throttle Position Switch (TPS) and wide open TPS are built into the throttle position sensor unit on most vehicles, on older vehicles the TPS is a separate unit. The wide open throttle position switch is used only for A/T control. When the throttle valve is in the closed position, the closed throttle position switch sends a voltage signal to the Engine Control Module (ECM). The ECM only uses this signal to open or close the EVAP canister purge volume control solenoid valve when the throttle position sensor is malfunctioning.

Audi Vehicle:Audi A1,Audi A3,Audi A1,Audi A3,Audi A1,Audi A3,Audi A4,Audi A5,Audi Q3,Audi A5,Audi Q5,Audi A3,Audi A4,Audi A5,Audi TT,Audi Q3,Audi Q5,Audi S3,Audi TTS,Audi RS 3,Audi TT RS,Audi A7,Audi Q7,Audi A8,Audi A6,Audi S4,Audi S5,Audi Q5,Audi S6,Audi S8,Audi S5,Audi A8,Audi R8 V8,Audi RS 5,Audi S6,Audi R8 V10,Audi R8 GT,Audi A8L