P0733 Isuzu Gear 3 Incorrect Ratio
Possible causes
– Low transmission fluid level
– Dirty transmission fluid
– Shift solenoids
– Transmission mechanical problems
– Transmission hydraulic control circuit
– Dirty transmission fluid
– Shift solenoids
– Transmission mechanical problems
– Transmission hydraulic control circuit
Tech description
Start by inspecting the transmission fluid level and condition, and change fluid if necessary.
What about the obd code?
P0733 Isuzu is detected when A/T cannot be shifted to the 3rd gear position even if electrical circuit is good.
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
– Incorrect transmission shifting
– Incorrect transmission shifting
P0733 Isuzu Description
This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:
Torque converter slip ratio = A x C/B
A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes
If the actual gear position is higher than the position (3rd) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.
Isuzu Vehicle:2013 Isuzu,2012 Isuzu,2011 Isuzu,2010 Isuzu,2009 Isuzu,2008 Isuzu,2007 Isuzu,2006 Isuzu,2005 Isuzu,2004 Isuzu,2003 Isuzu,2002 Isuzu,2001 Isuzu,2000 Isuzu,1999 Isuzu,1998 Isuzu,1997 Isuzu,1996 Isuzu,Isuzu Rodeo,Isuzu Trooper,Isuzu Ascender