P0734 Ford Gear 4 Incorrect Ratio
Possible causes
– Low transmission fluid level
– Dirty transmission fluid
– Shift solenoids
– Transmission mechanical problems
– Transmission hydraulic control circuit
– Dirty transmission fluid
– Shift solenoids
– Transmission mechanical problems
– Transmission hydraulic control circuit
Tech description
Start by inspecting the transmission fluid level and condition, and change fluid if necessary.
What about the obd code?
P0734 Ford is detected when A/T cannot be shifted to the 4th gear position even if electrical circuit is good.
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
– Incorrect transmission shifting
– Incorrect transmission shifting
P0734 Ford Description
This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:
Torque converter slip ratio = A x C/B
A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes
If the actual gear position is higher than the position (4th) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.
Ford Vehicle:Ford Escape,Ford Focus Flexifuel,Ford Mustang,Ford Fusion,Ford Taurus,Ford F-Series,Ford Explorer,Ford C-Max,Ford Escape,Ford Edge,Ford Explorer,Ford Flex,Ford Expedition,Ford Transit Connect,Ford F1-50,Ford E-Series Wagon,Ford Super Duty,Ford Fusion Hybrid SE,Ford C-MAX Hybrid SEL,Ford C-MAX Energi,Ford Fusion Energi SE,Ford Fucos Electric,Ford E-Series Van,Ford E-Series Cutaway,Ford Super Duty Pick Up,Ford Chassis Cab,Ford F-650/F-750,Ford Stripped Chassis