P0736 Audi Gear Ratio Error In Reverse Gear
Possible causes
– Low transmission fluid level
– Dirty transmission fluid
– Shift solenoids
– Transmission mechanical problems
– Transmission hydraulic control circuit
– Dirty transmission fluid
– Shift solenoids
– Transmission mechanical problems
– Transmission hydraulic control circuit
Tech description
Start by inspecting the transmission fluid level and condition, and change fluid if necessary.
What about the obd code?
The ECM has detected that the transmission input RPM does not match the transmission output RPM under known conditions
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
– Incorrect transmission shifting
– Incorrect transmission shifting
P0736 Audi Description
This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:
Torque converter slip ratio = A x C/B
A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes
Audi Vehicle:Audi A1,Audi A3,Audi A1,Audi A3,Audi A1,Audi A3,Audi A4,Audi A5,Audi Q3,Audi A5,Audi Q5,Audi A3,Audi A4,Audi A5,Audi TT,Audi Q3,Audi Q5,Audi S3,Audi TTS,Audi RS 3,Audi TT RS,Audi A7,Audi Q7,Audi A8,Audi A6,Audi S4,Audi S5,Audi Q5,Audi S6,Audi S8,Audi S5,Audi A8,Audi R8 V8,Audi RS 5,Audi S6,Audi R8 V10,Audi R8 GT,Audi A8L