P0804 Audi Skip Shift Lamp Control Circuit
Possible causes
– Faulty Skip Shift Lamp
– Skip Shift Lamp harness is open or shorted
– Skip Shift Lamp circuit poor electrical connection
– Skip Shift Lamp harness is open or shorted
– Skip Shift Lamp circuit poor electrical connection
What about the obd code?
When the Powertrain Control Module (PCM) commands the control circuit to a component OFF, the voltage potential of the circuit should be high (near battery voltage). If the fault detection circuit senses a voltage other than what is expected, the fault line status changes causing theP0804 Audi code is set.
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
P0804 Audi Description
An ignition voltage is supplied to the Skip Shift Lamp. The Powertrain Control Module (PCM) controls the lamp by grounding the control circuit via an internal switch called a driver. The driver supplies the ground for the component being controlled. Each driver has a fault line which the PCM monitors. When the PCM commands a component ON, the voltage of the control circuit should be low (near 0 volts).
Audi Vehicle:Audi A1,Audi A3,Audi A1,Audi A3,Audi A1,Audi A3,Audi A4,Audi A5,Audi Q3,Audi A5,Audi Q5,Audi A3,Audi A4,Audi A5,Audi TT,Audi Q3,Audi Q5,Audi S3,Audi TTS,Audi RS 3,Audi TT RS,Audi A7,Audi Q7,Audi A8,Audi A6,Audi S4,Audi S5,Audi Q5,Audi S6,Audi S8,Audi S5,Audi A8,Audi R8 V8,Audi RS 5,Audi S6,Audi R8 V10,Audi R8 GT,Audi A8L