P1120 Isuzu Throttle Position Sensor 1 Circuit
Possible causes
– Faulty Throttle Position Sensor
– Throttle Position Sensor harness is open or shorted
– Throttle Position Sensor circuit poor electrical connection
– Throttle Position Sensor not properly adjusted
– Throttle Position Sensor harness is open or shorted
– Throttle Position Sensor circuit poor electrical connection
– Throttle Position Sensor not properly adjusted
What about the obd code?
When the Powertrain Control Module (PCM) senses a signal voltage higher than the normal operating range of the sensor, the P1120 Isuzu will set.
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
P1120 Isuzu Description
The Throttle Position (TP) sensor is a potentiometer. The TP sensor provides a voltage signal that changes relative to throttle blade angle. This signal voltage is one of the most important inputs used by the Powertrain Control Module (PCM). The TP sensor has a 5.0 volt reference, a ground and a signal circuit.
TP sensor Signal voltage should be about 0.6 volt at idle. The TP sensor voltage should increase to above 4.0 volts at wide open throttle (WOT).
Isuzu Vehicle:2013 Isuzu,2012 Isuzu,2011 Isuzu,2010 Isuzu,2009 Isuzu,2008 Isuzu,2007 Isuzu,2006 Isuzu,2005 Isuzu,2004 Isuzu,2003 Isuzu,2002 Isuzu,2001 Isuzu,2000 Isuzu,1999 Isuzu,1998 Isuzu,1997 Isuzu,1996 Isuzu,Isuzu Rodeo,Isuzu Trooper,Isuzu Ascender