P1641 Audi FC Relay 1 Control Circuit

P1641 Audi FC Relay 1 Control Circuit

Possible causes

– Faulty Cooling Fan Relay
– Cooling Fan Relay harness is open or shorted
– Cooling Fan Relay circuit poor electrical component

Symptoms

– Engine Light ON (or Service Engine Soon Warning Light)
– Cooling Fan not working

P1641 Audi Description

Ignition voltage is supplied to the Cooling Fan relay coil. The Powertrain Control Module (PCM) controls the relay by grounding the control circuit via an internal switch called a driver. The primary function of the driver is to supply the ground for the component being controlled. Each driver has a fault line which is monitored by the PCM. When the PCM is commanding a component ON, the voltage of the control circuit should be lo (near 0 volts). When the PCM is commanding the control circuit to a component OFF, the voltage potential of the circuit should be high (near battery voltage). If the fault detection circuit senses a voltage other than what is expected, the fault line status will change causing the code to set.

The relay is used to control the high current flow to the cooling fan motors. This allows the PCM driver to only have to handle the relatively low current used by the raly.

Audi Vehicle:Audi A1,Audi A3,Audi A1,Audi A3,Audi A1,Audi A3,Audi A4,Audi A5,Audi Q3,Audi A5,Audi Q5,Audi A3,Audi A4,Audi A5,Audi TT,Audi Q3,Audi Q5,Audi S3,Audi TTS,Audi RS 3,Audi TT RS,Audi A7,Audi Q7,Audi A8,Audi A6,Audi S4,Audi S5,Audi Q5,Audi S6,Audi S8,Audi S5,Audi A8,Audi R8 V8,Audi RS 5,Audi S6,Audi R8 V10,Audi R8 GT,Audi A8L