P1646 Isuzu EVAP Vent Solenoid Output Circuit
Possible causes
– Faulty EVAP Vent Solenoid
– EVAP Vent Solenoid harness is open or shorted
– EVAP Vent Solenoid circuit poor electrical connection
– EVAP Vent Solenoid harness is open or shorted
– EVAP Vent Solenoid circuit poor electrical connection
What about the obd code?
The Powertrain Control Module (PCM) has detected the EVAP Vent Solenoid circuit was low
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
P1646 Isuzu Description
The Powertrain Control Module (PCM) contains chips called Output Driver Modules that provide 7 switchable ground outputs for operating solenoids, relays, telltales, and other devices. Each of these ground outputs has an internal fault line that feeds back to the PCMs microprocessor. When the output is OFF, the output driver should receive the 12 volts fed to the solenoid, relay, etc. When the output is ON, it should receive 0 volt since it is grounding the output. If it receives 0 volt when the output is OFF or 12 volts when the output is ON, it sets the fault line low.
Isuzu Vehicle:2013 Isuzu,2012 Isuzu,2011 Isuzu,2010 Isuzu,2009 Isuzu,2008 Isuzu,2007 Isuzu,2006 Isuzu,2005 Isuzu,2004 Isuzu,2003 Isuzu,2002 Isuzu,2001 Isuzu,2000 Isuzu,1999 Isuzu,1998 Isuzu,1997 Isuzu,1996 Isuzu,Isuzu Rodeo,Isuzu Trooper,Isuzu Ascender