P2305 Isuzu Ignition Coil Secondary Number 2 Circuit Condition

P2305 Isuzu Ignition Coil Secondary Number 2 Circuit Condition

Possible causes
– Faulty spark plug or coil boot
– Faulty Ignition Coil 2
– Ignition Coil 2 harness is open or shorted
– Ignition Coil 2 circuit poor electrical connection
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
– Engine may be running rough
P2305 Isuzu Description

The ignition system is controlled by the Powertrain Control Module (PCM) on all engines. Each cylinder is equipped with 1 dual-output coil. Meaning one coil mounts directly over one of the dual spark plugs for 1 high-voltage output.

Battery voltage is supplied to all of the ignition coils positive terminals from the ASD relay. If the PCM does not see a signal from the crankshaft and camshaft sensors (indicating the ignition key is ON but the engine is not running), it will shut down the ASD circuit.

Base ignition timing is not adjustable. By controlling the coil ground circuits, the PCM is able to set the base timing and adjust the ignition timing advance. This is done to meet changing engine operating conditions.

The PCM adjusts ignition timing based on inputs it receives from:

– The engine coolant temperature sensor

– The crankshaft position sensor (engine speed)

– The camshaft position sensor (crankshaft position)

– The manifold absolute pressure (MAP) sensor

– The throttle position sensor

– Transmission gear selection

Isuzu Vehicle:2013 Isuzu,2012 Isuzu,2011 Isuzu,2010 Isuzu,2009 Isuzu,2008 Isuzu,2007 Isuzu,2006 Isuzu,2005 Isuzu,2004 Isuzu,2003 Isuzu,2002 Isuzu,2001 Isuzu,2000 Isuzu,1999 Isuzu,1998 Isuzu,1997 Isuzu,1996 Isuzu,Isuzu Rodeo,Isuzu Trooper,Isuzu Ascender
CategoriesUncategorized