Связь с автомобилем — отправная точка. Уточняйте двигатель, период выпуска и ПО по данным производителя.
P0108 ← Что означает этот код?23 Результаты
CADILLAC, CHEVROLET, GMC · 2021-05-11
Service Update Bulletin. Certain vehicles may have an erratic signal coming from the engine manifold absolute pressure (MAP) sensor. Customers may notice the service engine soon (SES) lamp illuminate or was illuminated and turned off. DTC?s P0106 and P0108 may also be present as active or stored in history. Dealers will replace the MAP sensor.
CADILLAC, CHEVROLET, GMC · 2021-03-22
This Preliminary information communicates Some customers may comment that the SES lamp is illuminated or was Illuminated and turned off. During inspection Technician may notice DTC, P0106 (Manifold Absolute Pressure Sensor Performance), P0108 (Manifold Absolute Pressure Sensor Circuit High) and/or P00C7 (Intake Air Pressure Measurement System Sensor and Multiple Sensors Correlation) codes active or stored in history. This condition may be caused by a faulty Manifold Absolute Pressure (MAP) sensor.
CADILLAC, CHEVROLET, GMC · 2021-03-17
This Preliminary information communicates Some customers may comment that the SES lamp is illuminated or was Illuminated and turned off. During inspection Technician may notice DTC, P0106 (Manifold Absolute Pressure Sensor Performance), P0108 (Manifold Absolute Pressure Sensor Circuit High) and/or P00C7 (Intake Air Pressure Measurement System Sensor and Multiple Sensors Correlation) codes active or stored in history. This condition may be caused by a faulty Manifold Absolute Pressure (MAP) sensor.
RAM · 2020-04-03
Customer complaint may include MIL/Check Engine lamp on, other driveability complaints. Upon further investigation, fault codes P0107- Map Sensor Circuit Low, P0108-Map Sensor Circuit High, P2172-High Airflow/Vacuum Leak Detected (Instantaneous Accumulation), P2173-High Airflow/Vacuum Leak Detected (Slow Accumulation) may be set in the powertrain control module (PCM).
FORD, LINCOLN · 2019-07-03
Some 2018-2019 Explorer/Flex/Taurus/MKT vehicles equipped with a 3.5L EcoBoost engine may exhibit an illuminated malfunction indicator lamp (MIL), powertrain malfunction (wrench) lamp, Service AdvanceTrac message, Hill Start Assist Not Available message, and/or lack of power with diagnostic trouble codes (DTCs) P0107, P0108 and/or P0109 present. This may be due to a faulty manifold absolute pressure and temperature (MAPT) sensor. To correct the condition, follow the Service Procedure to replace the MAPT sensor.
FORD, LINCOLN · 2019-07-03
Some 2018-2019 Explorer/Flex/Taurus/MKT vehicles equipped with a 3.5L EcoBoost engine may exhibit an illuminated malfunction indicator lamp (MIL), powertrain malfunction (wrench) lamp, Service AdvanceTrac message, Hill Start Assist Not Available message, and/or lack of power with diagnostic trouble codes (DTCs) P0107, P0108 and/or P0109 present. This may be due to a faulty manifold absolute pressure and temperature (MAPT) sensor. To correct the condition, follow the Service Procedure to replace the MAPT sensor.
FORD, LINCOLN · 2019-06-05
Some 2018-2019 Explorer/Flex/Taurus/MKT vehicles equipped with a 3.5L EcoBoost engine may exhibit an illuminated malfunction indicator lamp (MIL), powertrain malfunction (wrench) lamp, Service AdvanceTrac message, Hill Start Assist Not Available message, and/or lack of power with diagnostic trouble codes (DTCs) P0107, P0108 and/or P0109 present. This may be due to a faulty manifold absolute pressure and temperature (MAPT) sensor. To correct the condition, follow the Service Procedure steps to diagnose and replace the MAPT sensor.
CHRYSLER, DODGE · 2016-06-29
"FLASH: POWERTRAIN DIAGNOSTIC AND SYSTEM IMPROVEMENTS THIS BULLETIN INVOLVES SELECTIVELY ERASING AND REPROGRAMMING THE POWERTRAIN CONTROL MODULE (PCM) WITH NEW SOFTWARE. SYMPTOM/CONDITION: A SMALL NUMBER OF CUSTOMERS MAY EXPERIENCE A MALFUNCTION INDICATOR LAMP (MIL) ILLUMINATION. UPON FURTHER INVESTIGATION THE TECHNICIAN MAY FIND ONE OR MORE OF THE FOLLOWING DIAGNOSTIC TROUBLE CODES (DTCS) SET IN THE PCM: JC VEHICLES 3.6L: · P0335 - CRANKSHAFT POSITION SENSOR CIRCUIT. · P2610 - PCM INTERNAL ENGINE OFF TIMER PERFORMANCE. · U0140 - LOST COMMUNICATION WITH BODY CONTROL MODULE (BCM). · P0456 - EVAP SYSTEM SMALL LEAK. · P0108 - MANIFOLD ABSOLUTE PRESSURE SENSOR CIRCUIT HIGH (2012 MY ONLY). THE FOLLOWING TRANSMISSION ENHANCEMENTS ARE ALSO INCLUDED IN THIS SOFTWARE UPDATE: · CONTINUOUS CYCLING…
DODGE · 2015-12-12
Flash: 3.6L Powertrain Diagnostic And System Enhancements This bulletin involves flash reprogramming the Powertrain Control Module (PCM) with new software. NOTE: There will be two software packages to choose from. Both software updates will fix all symptoms/conditions listed. One will contain a enhanced accelerator pedal operation and one will not. Refer to the ?Symptoms/Conditions? for a detailed description of the changes. Be sure to consult with the Customer on what software version they prefer, Enhanced Pedal or Standard Pedal. Once the software choice is programmed it is a permanent change. NOTE: There is another software choice available, in addition to addressing all the symptom/conditions listed. This new version of software called Enhanced Pedal has an update to the accelerator…
CHRYSLER, DODGE · 2015-11-11
Powertrain System Improvements/Enhancements This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. The customer may describe hearing the fuel pump relay cycling during remote start or a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find one or more of the following Diagnostic Trouble Codes (DTCs) set in the PCM: ? U0140 - Lost Communication With Body Control Module (BCM). ? P06DD - Engine Oil Pressure Control Circuit Stuck Off. ? P0522 - Engine Oil Pressure Sensor Circuit Low. ? P0108 - Manifold Absolute Pressure Sensor Circuit High. ? P1239 - Engine Oil Temperature Too Low. ? P0298 - Engine Oil Temperature Too High.
DODGE · 2015-09-25
Flash: Diagnostic And System Improvements This bulletin involves reprogramming the Powertrain Control Module (PCM) with updated software. The technician may find the following Diagnostic Trouble Code (DTCs) set in the Powertrain Control Module (PCM) memory: ? U0140 - Lost Communication With Body Control Module. (3.6L engine only). NOTE: Attempting to clear this DTC will be unsuccessful. Some customers may experience any of the following: ? Continuous cycling of fuel pump relay when using remote start (3.6L engines) ? Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the Technician may find that P0108 - Manifold Absolute Pressure Sensor Circuit High has been set active or stored (3.6L engine) NOTE: MIL Illumination for P0108 - Manifold Absolute Pressure Sensor…
SUBARU · 2015-08-10
"THIS SERVICE INFORMATION BULLETIN REVIEWS A DESIGN CHANGE TO THE ENGINE WIRING HARNESS TO ELIMINATE IMPROPER DIAGNOSIS OF THE EVAPORATIVE LEAK CHECK MODULE (ELCM) BY THE ECM WHICH COULD SET DIAGNOSTIC TROUBLE CODE (DTC) P0451 IN ERROR. SOME EXAMPLES OF OTHER DTCS AFFECTED BY THIS HARNESS CHANGE ARE: P0068, P0452, P0453, P0107, P0108 AND P0300. THE CHANGE INVOLVES A REPOSITIONING OF THE SENSOR AND ACTUATOR WIRING GROUND JUNCTION POINT TO A LOCATION UNAFFECTED BY ENGINE MOVEMENT AND HIGH TEMPERATURES (NEAR TURBOCHARGER) WHICH MAY DEVELOP EXCESSIVE RESISTANCE. SINCE THIS CONDITION DEVELOPS OVER TIME, DTC(S) MAY SET VERY INTERMITTENTLY WITH LONG PERIODS OF TIME BETWEEN OCCURRENCES. A MORE FREQUENT OCCURRENCE OF ANY OF THESE DTC(S) MAY INDICATE A DIFFERENT ROOT CAUSE OTHER THAN THE CONDITION…
DODGE, JEEP · 2013-03-19
Flash: MIL Illumination P0108- Manifold Absolute Pressure Sensor Circuit High This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the Technician may find that the following Diagnostic Trouble Code has been set: P0108- Manifold Absolute Pressure Sensor Circuit High
VOLKSWAGEN · 2013-03-05
MIL ON DTC P0108 Manifold Absolute Pressure Sensor Circuit High Stored in ECM Fault Memory
DODGE · 2013-02-21
Flash: MIL Illumination P0108 - Manifold Absolute Pressure Sensor Circuit High And Transmission Shift Improvements This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. The customer may experience any of the following: 3.6L engine. MIL Illumination for P0108 - Manifold Absolute Pressure Sensor Circuit High affects only 2012 model year vehicles equipped with a 3.6L engine (sales code ERB). 2.4L & 3.6L engines 2.4L & 3.6L engines 2.4L & 3.6L engines 3.6L engine 3.6L engine 3.6L engine 2.4L & 3.6L engines 2.4L engine 2.4L engine 2.4L engine Improves the consistency of how shifts are controlled during upshifts ?torque management?. 3.6L engine Updating the software will correct the conditions listed above.
DODGE · 2013-02-21
Flash: MIL Illumination P0108 - Manifold Absolute Pressure Sensor Circuit High And Transmission Shift Improvements This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. The customer may experience any of the following: 3.6L engine. MIL Illumination for P0108 - Manifold Absolute Pressure Sensor Circuit High affects only 2012 model year vehicles equipped with a 3.6L engine (sales code ERB). 2.4L & 3.6L engines 2.4L & 3.6L engines 2.4L & 3.6L engines 3.6L engine 3.6L engine 3.6L engine 2.4L & 3.6L engines 2.4L engine 2.4L engine 2.4L engine Improves the consistency of how shifts are controlled during upshifts ?torque management?. 3.6L engineUpdating the software will correct the conditions listed above.
CHRYSLER, DODGE · 2012-12-15
Flash: MIL Illumination P0108 - Manifold Absolute Pressure Sensor Circuit High This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. The customer may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the Technician may find that P0108 - Manifold Absolute Pressure Sensor Circuit High has been set active or stored.Updating the software will correct the condition listed above.
DODGE · 2012-11-29
Flash: MIL Illumination P0108 - Manifold Absolute Pressure Sensor Circuit High This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. The customer may indicate that their Malfunction Indicator Lamp (MIL) is illuminated. Upon further investigation the Technician may find that P0108 - Manifold Absolute Pressure Sensor Circuit High has been set active or stored.Updating the software will correct the condition listed above.
DODGE · 2012-11-03
Flash: MIL Illumination P0108 - Manifold Absolute Pressure Sensor Circuit High And Transmission Shift Improvements This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. The customer may experience any of the following: 3.6L engine. MIL Illumination for P0108 - Manifold Absolute Pressure Sensor Circuit High affects 2012 model year vehicles only. 2.4L & 3.6L engines 2.4L & 3.6L engines 2.4L & 3.6L engines 3.6L engine 3.6L engine 3.6L engine 2.4L & 3.6L engines 2.4L engine 2.4L engine 2.4L engine Improves the consistency of how shifts are controlled during upshifts ?torque management?Updating the software will correct the condition listed above.
CHEVROLET, GMC · 2009-09-01
CHEVROLET/GMC: WIRE HARNESS CHAFES NEAR AIR CLEANER AND DUCTWORK. MAY ENCOUNTER A CONCERN OF REDUCED POWER MODE OR THE SES LIGHT ON WITH DTCS P0101, P0106, P0107, P0108, P0299, P0652 SETTING. *PE
CHEVROLET, GMC · 2007-01-01
REDUCED ENGINE POWER, SES LIGHT ILLUMINATED, DTC'S P0107 OR P0108 SET DUE TO MAP SENSOR DISCONNECTION (REPLACE AIR CLEANER ASSEMBLY AND RECONNECT MAP SENSOR CONNECTOR). *KB
HONDA · 2004-08-10
ROUGH IDLE AT COLD START; MALFUNCTION INDICATOR LAMP (MIL) COMES ON WITH DIAGNOSTIC P0107 OR P0108. *MJ UPDATE. *TT
FORD · 2003-05-01
IMPROVED DIAGNOSTICS FOR DIAGNOSTIC TROUBLE CODE P0107 - P0108. *TT