P010B · Материалы производителя

FORD · 2023-11-23

Some 2024 Mustang vehicles built on or before 5-Oct-2023 and equiped with a 5.0L engine may exhibit an illuminated MIL with DTC P0101 and/or P010B in the powertrain control module (PCM). This may be due to the software level of the PCM. To correct this condition, perform the Service Procedure below to reprogram the PCM to the latest software level via the Ford Diagnosis and Repair System (FDRS).

NISSAN · 2023-01-18

MIL ON WITH DTC P0101 AND/OR P010B STORED IN THE ECM SERVICE INFORMATION If the MIL is ON and DTC P0101 (MAF SEN/CIRCUIT-B1) and/or DTC P010B (MAF SEN/CIRCUIT-B2) is stored in the ECM on an APPLIED VEHICLE, follow the information in this bulletin along with the ESM to complete the required repairs.

INFINITI · 2023-01-18

MIL ON WITH DTC P0101 AND/OR P010B STORED IN THE ECM SERVICE INFORMATION If the MIL is ON and DTC P0101 (MAF SEN/CIRCUIT-B1) and/or DTC P010B (MAF SEN/CIRCUIT-B2) is stored in the ECM on an APPLIED VEHICLE, follow the information in this bulletin along with the ESM to complete the required repairs.

INFINITI · 2019-02-28

MIL ON WITH DTC P0101, P010B, AND/OR P0106 This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

INFINITI · 2017-03-06

MIL ON WITH DTC P0101, P010B, AND/OR P0106 This bulletin applies only to vehicles equipped with a V6 twin turbo engine. IF YOU CONFIRM The MIL is ON with one or more of the following DTCs stored: - P0101 (MAF SEN/CIRCUIT-B1) - P010B (MAF SEN/CIRCUIT-B2) - P0106 (ABSL PRES SEN/CIRC) and There are no drivability issues. ACTION 1. Refer to step 6 in the SERVICE PROCEDURE to confirm this bulletin applies to the vehicle you are working on. 2. If this bulletin applies, reprogram the ECM.

INFINITI · 2015-07-22

IF YOU CONFIRM: The MIL is ON with DTC P0101 and/or P010B (MAF SEN/CIRCUIT-B1/B2) and there are no drivability issues. ACTION: 1. Refer to step 6 in the SERVICE PROCEDURE to confirm this bulletin applies to the vehicle you are working on. 2. If this bulletin applies, reprogram the ECM. NOTE: If this bulletin does apply (the ECM needs to be reprogrammed), do NOT replace the mass air flow sensor(s). See this bulletin for further detail.

NISSAN · 2015-06-30

IF YOU CONFIRM: The MIL is ON with DTC P0101 and/or P010B (MAF SEN/CIRCUIT-B1/B2) and there are no drivability issues. ACTION: 1. Refer to step 6 in the SERVICE PROCEDURE to confirm this bulletin applies to the vehicle you are working on. 2. If this bulletin applies, reprogram the ECM. NOTE: If this bulletin does apply (the ECM needs to be reprogrammed), do NOT replace the mass air flow sensor(s). See this bulletin for further detail.