P16F0 · Материалы производителя

CHRYSLER · 2026-05-27

Flash: Hybrid Control Processor (HCP) / Auxiliary Hybrid Control Processor (AHCP) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● P0E15-00 - Hybrid-EV Battery Pack Coolant Heater A Control Performance. ● P16F0-00 - SPI Comm Hardware Fault. ● P16F1-00 - Internal SPI Communication. Customers may experience the following: ● Vehicle does not start / engine does not crank. ● Extended engine cranking time when starting the vehicle. ● Clunk noise heard while the vehicle is moving. ● Transmission fluid is leaking and may prohibit vehicle movement. ● Vehicle does not move when shifted into Drive or Reverse gear. ● Loss of heat from the engine. ● Vehicle may lose…

CHRYSLER · 2026-02-26

Flash: Auxiliary Hybrid Control Processor (AHCP) / Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must SYMPTOM: exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● **P0E15-00 - Hybrid-EV Battery Pack Coolant Heater A Control Performance. ● P29BB-00 - Hybrid-EV Battery Pack Coolant Heater A Control Performance.** ● P16F0-00 - SPI Comm Hardware Fault. ● P16F1-00 - Internal SPI Communication. Customers may experience the following: ● **Vehicle does not start / engine does not crank. ● Extended engine cranking time when starting the vehicle. ● Clunk noise heard while the vehicle is moving. ● Transmission fluid is leaking and may prohibit vehicle movement. ● Vehicle does not move when shifted into Drive or Reverse gear. ● Loss…

CHRYSLER · 2025-12-18

Flash: Power Inverter Module (PIM) Flash Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● P16F0-00 - SPI Comm Hardware Fault. ● P16F1-00 - Internal SPI Communication. Customers may experience the following: ● Vehicle may lose propulsion capability upon entering Ready Mode. ● Vehicle may lose propulsion while driving in electric mode. Prior to that, a warning message will appear in the cluster informing them to stop safely because the vehicle will be shutting down soon. After shutting down, the vehicle may not be able to start again. Failure may occur between driving cycles and may not start after trying to turn it on for the first time during a day. This…

JEEP · 2025-10-28

Flash: Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find the following Diagnostic Trouble Code (DTC) has been set in the Hybrid Control Processor (HCP) module: ● P16F0-00 - SPI Comm Hardware Fault. Customers may also comment on one or more of the following: ● **Low/weak 12V battery or a no start condition due to voltage being under 10.5V. ● Unable to charge vehicle while key is off.** ● Shifts rough occasionally when coming down to a stop. ● Shifts rough occasionally when accelerating. ● Shifts rough when transitioning from EV to Hybrid operation on low SoC. ● Shifts rough when engines starts. ● On part throttle accelerations with…

JEEP · 2025-05-18

"Flash: Powertrain Control Module (PCM) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● P0629 - Fuel Pump Control Circuit High. ● P0171 - Fuel system Lean. ● P0087 - Fuel Rail Pressure Too Low – Bank 1. ● P16F0-00 - SPI Comm Hardware Fault. Customers may also experience one or more of the following: ● **Engine No Start.** ● The rear shafts can be damaged from pressing the accelerator while in gear with the Electronic Parking Brake (EPB) applied. ● Oxygen sensors can give wrong values entering EV mode. False fault detection is possible. ● The Instrument Panel Cluster (IPC) is unable to calculate the instantaneous fuel economy when under heavy acceleration. ●…

JEEP · 2025-01-11

"Flash: Transmission Control Module (TCM) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● P0810-00 - Clutch Position Control Error. ● P16F0-00 - SPI Comm Hardware Fault. Customers may also comment on one or more of the following: ● K0 Adaptation routine runs when vehicle stationary and EV Mode. ● Vehicle loses propulsion capability. ● Service transmission warning indicator is on. NOTE: Require key cycle to recover. ● Shifts rough occasionally when coming down to a stop. ● Shifts rough occasionally when accelerating. ● Shifts rough when transitioning from EV to Hybrid operation on low SoC. ● Shifts rough when engines starts. ● On part throttle accelerations…

JEEP · 2024-09-07

"Flash: Powertrain Control Module (PCM) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician must find one or more of the following Diagnostic Trouble Codes (DTCs) have been set: ● **P0629 - Fuel Pump Control Circuit High. ● P0171 - Fuel system Lean. ● P0087 - Fuel Rail Pressure Too Low - Bank 1.** ● P16F0-00 - SPI Comm Hardware Fault. Customers may also experience one or more of the following: ● **The rear half shafts are damaged due to pressing the accelerator in drive with the Electric Parking Brake (EPB) applied. ● The Oxygen Sensor (02) can give wrong values when entering EV mode, triggering a false MIL. ● The Instrument Cluster Panel (ICP) unable to calculate the instantaneous fuel economy under heavy…

JEEP · 2024-05-10

"Flash: Transmission Control Module (TCM) Updates **Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs):** ● P0810-00 - Clutch Position Control Error. ● P16F0-00 - SPI Comm Hardware Fault. Customers may also comment on one or more of the following: ● K0 Adaptation routine runs when vehicle stationary and EV Mode. ● Vehicle loses propulsion capability. ● Service transmission warning indicator is on. NOTE: Require key cycle to recover. ● Shifts rough occasionally when coming down to a stop. ● Shifts rough occasionally when accelerating. ● Shifts rough when transitioning from EV to Hybrid operation on low SoC. ● Shifts rough when engines starts. ● On part throttle accelerations…

JEEP · 2024-01-10

Flash: Transmission Control Module (TCM) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find the following Diagnostic Trouble Code (DTC) has been set in the Hybrid Control Processor (HCP) module: ? P16F0-00 - SPI Comm Hardware Fault. Customers may also comment on one or more of the following: ? Shifts rough occasionally when coming down to a stop. ? Shifts rough occasionally when accelerating. ? Shifts rough when transitioning from EV to Hybrid operation on low SoC. ? Shifts rough when engines starts. ? On part throttle accelerations with little to no battery available the transition from battery power to engine on is harsh and abrupt. ? The engine oil life on dashboard drops down too fast when the engine oil…

JEEP · 2024-01-10

Flash: Powertrain Control Module (PCM) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find the following Diagnostic Trouble Code (DTC) has been set in the Hybrid Control Processor (HCP) module: ? P16F0-00 - SPI Comm Hardware Fault. Customers may also comment on one or more of the following: ? Shifts rough occasionally when coming down to a stop. ? Shifts rough occasionally when accelerating. ? Shifts rough when transitioning from EV to Hybrid operation on low SoC. ? Shifts rough when engines starts. ? On part throttle accelerations with little to no battery available the transition from battery power to engine on is harsh and abrupt. ? The engine oil life on dashboard drops down too fast when the engine oil…

JEEP · 2024-01-10

Flash: Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find the following Diagnostic Trouble Code (DTC) has been set in the Hybrid Control Processor (HCP) module: ? P16F0-00 - SPI Comm Hardware Fault. Customers may also comment on one or more of the following: ? Shifts rough occasionally when coming down to a stop. ? Shifts rough occasionally when accelerating. ? Shifts rough when transitioning from EV to Hybrid operation on low SoC. ? Shifts rough when engines starts. ? On part throttle accelerations with little to no battery available the transition from battery power to engine on is harsh and abrupt. ? The engine oil life on…

JEEP · 2023-11-01

Flash: Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) Updates **Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find the following Diagnostic Trouble Code (DTC) has been set in the Hybrid Control Processor (HCP) module: ? P16F0-00 - SPI Comm Hardware Fault. Customer may experience one or more of the following: ? Unexpected engine start during a crank (customer is expecting EV mode but the gas engine starts).** ? ?Service Charging System? popup when keying the vehicle to off while still in drive. ? Engine must be started twice to achieve drive ready (at low temperatures around 30°C, 22°F) when the vehicle was entered and started quickly. ? Radiator fan cycling while in park and with…