P204F · Материалы производителя

RAM · 2015-03-14

Flash: 3.0L Powertrain Diagnostic And System Enhancements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. It also involves replacement of the Oxygen (O2) Sensor and cleaning or replacement of the Exhaust Gas Temperature (EGT) Sensor 1/2 if necessary depending on Diagnostic Trouble Codes (DTC) that may have set. A small number of customers may experience an intermittent engine shudder or vibration which may not set a Diagnostic Trouble Code (DTC). In addition other customers may experience a Malfunction Indicator Lamp (MIL) illumination upon which the technician may find one or more of the following DTCs have been set: ? P20C2 - Reductant Heater 3 Control Circuit Performance. ? P204F - Reductant System Performance. ? P20E9 -…

JEEP · 2015-03-14

Flash: 3.0L Powertrain Diagnostic And System Enhancements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation a technician may find one of more of the following Diagnostic Trouble Codes (DTCs) set in the PCM memory. ? P20C2 - Reductant Heater 3 Control Circuit Performance. ? P204F - Reductant System Performance. ? P20E9 - Reductant Pressure Too High.

JEEP · 2015-03-14

Flash: 3.0 L MIL Illumination Diagnostic and System Improvements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the Technician may find one or more of the following Diagnostic Trouble Code(s) may have been set: ? P20C2 - Reductant Heater 3 Control Circuit Performance. ? P204F - Reductant System Performance. ? P20E9 - Reductant Pressure Too High. ? P0087-00 - Fuel Rail Pressure Too Low. ? P20EE-00 - SCR NOX Catalyst Efficiency Below Threshold Bank 1. ? P0171-00 - System Too Lean (Bank 1). ? P0172-00 - System Too Rich (Bank 1). ? P225C-00 - NOX Sensor Performance - Signal Stuck High Bank 1 Sensor 1. ? P225D-00 -…

RAM · 2015-03-04

Flash: 3.0L Powertrain Diagnostic And System Enhancements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation a technician may find one of more of the following Diagnostic Trouble Codes (DTCs) set in the PCM memory. ? P20C2 - Reductant Heater 3 Control Circuit Performance. ? P204F - Reductant System Performance. ? P20E9 - Reductant Pressure Too High. ? P016A-00 - Excessive Time To Enter Closed Loop Air/Fuel Ratio Control. In addition to addressing the above DTCs, the following powertrain system improvements/enhancements are also included in this software release. ? Enhancements to improve A/C compressor relay duty…

HINO · 2014-08-26

A subject vehicle may exhibit an illuminated check engine lamp with DTC (Diagnostic Trouble Code) P204F (Malfunction of urea SCR System). The DTC P204F cannot be cleared until the DCU codes have been repaired, cleared and the SCR related memory has been reset with the below procedure.

HINO · 2014-08-26

TT-14-025 A subject vehicle may exhibit an illuminated check engine lamp with DTC (Diagnostic Trouble Code) P204F (Malfunction of urea SCR System). The DTC P204F cannot be cleared until the DCU codes have been repaired, cleared and the SCR related memory has been reset with the below procedure.

HINO · 2013-07-24

13-010 CORRECTION OF WORKSHOP MANUALS. HINT: In case the DTC P204F has being recorded in the engine ECU, but no DTC has been detected in the DCU, it is safe to think that power supply to the DCU was interrupted before the DTC was recorded into the DCU. In that case, please check for corrosion or abnormalities on the battery terminal. If there is abnormality, clean or replace the battery terminal, and after deleting past DTC, please verify again if P204F is detected.

FORD · 2013-06-18

FORD: WHILE OPERATING IN LOW SPEED CONDITIONS AND/OR WHEN OPERATING IN STATIONARY IDLE MODE FOR AN EXTENDED PERIODS OF TIME, WILL EXPERIENCE AN ILLUMINATION OF MIL AND DTC P207F, WITH OR WITHOUT, DTC P204F, PREVENTING TRUCK FROM FULLY COMPLETING EXHAUST REGENERATION PROCESS. MODEL 2012 F-350. *PE

FORD · 2013-05-16

FORD: WHEN TRUCK IS PREVENTED, AFTER AN EXTENDED TIME PERIOD OF STATIONARY IDLENESS OR LOW SPEED DRIVING, IT FAILS TO COMPLETE EXHAUST REGENERATION PROCESS AND ILLUMINATES MIL AND DTC P207F WITH/WITHOUT DTC P204F. MODEL 2012 F-450, 550. *PE

HINO · 2012-10-04

Some engines may erroneously record a P202E DTC in the DCU along with a P204F in the ECU. This fault condition is due to DCU software misdetection of DEF system pressure being delivered to the DEF injector.

HINO · 2012-10-04

12 - 002 Diagnosis Procedure for P202E (DCU) Associated with P204F (ECU) Some engines may erroneously record a P202E DTC in the DCU along with a P204F in the ECU. This fault condition is due to DCU software misdetection of DEF system pressure being delivered to the DEF injector.