HINO

167-B1624-12

2016-08-02 · NHTSA 10117751

车型关联可作为查阅线索；具体发动机、生产范围和软件条件请核对厂商资料。

厂商摘要

以下为英文原文

SB-16-020 An enhanced fuel cut valve is available to address a potential sticking condition that results in excess residual pressure in the dosing injector (7thinjector) supply pipe. A sticking fuel cut valve may result in the following DTC?s (diagnostic trouble codes) setting: 1. If DTC P0005 (fuel cut valve stuck closed) sets in the engine ECU, replace the fuel cut valve with the part number listed below. 2. If DTC P20DE (pressure sensor performance invalid) or DTC P20DF (pressure sensor signal too low) set in the engine ECU, this could be a result of the fuel cut valve sticking. Follow the workshop manual diagnostic procedure in section 4 of the Hino Workshop Manual (J05E Engine Control System) for the DTC. Also, inspect for signs of fuel contamination that could restrict the fuel filter or bubble separator filter. If no issues are identified with fuel contamination, and the workshop manual procedure does not identify a concern, replace the fuel cut valve with the part number listed below.

仅当厂商、通报编号、发布日期和完整摘要一致时，重复登记才会合并展示，原始编号仍予保留。旧资料继续供查阅；确认明确替代关系后才标示后续版本。1994 年以前的车辆关联与默认结果分开显示；未注明年款不等于适用于所有年款。