CHEVROLET

PIT5369A

2015-03-04 · NHTSA 10139316

车型关联可作为查阅线索；具体发动机、生产范围和软件条件请核对厂商资料。

厂商摘要

以下为英文原文

This Preliminary Information communication provides information to the technician about vehicles that may have a crank no start issue after sitting overnight below the freezing point. Technician may find Diagnostic Trouble Code U1000. Technician will gain access to the engine harness above the fuel rail. After gaining access to the harness unsecure the harness from the retainers. Now the conduit can be opened to gain access to the wires. Technician will need to find the largest gauge red wire and violate with purple wire in the harness in sure these are the largest gauge wires. After finding the correct wires cut the violate with purple wire near the middle of the wiring that is accessible then cut the red 13mm (.50 inch) longer. Technician will need to strip both violate with purple wires sides and then the top red wire. Do not strip the bottom red wire. After the wires are stripped twist the top red wire and violate with purple wire together. Install a DuraSeal splice sleeve part number 19168447 (Blue) or equivalent to the exposed wires, using the EL-38125-10 splice sleeve crimping tool crimp in the number three nest. Technician will need to gently pull the wires to insure there is a good crimp then heat the splice sleeve with a heat gun to 500 to 700 degrees Fahrenheit. The wires will need to be taped up and placed back in the conduit. Reinstall all the parts that were removed to gain access to the harness and retest.

仅当厂商、通报编号、发布日期和完整摘要一致时，重复登记才会合并展示，原始编号仍予保留。旧资料继续供查阅；确认明确替代关系后才标示后续版本。1994 年以前的车辆关联与默认结果分开显示；未注明年款不等于适用于所有年款。