RAM

08-073-20

2020-08-07 · NHTSA 10180255

车型关联可作为查阅线索；具体发动机、生产范围和软件条件请核对厂商资料。

厂商摘要

以下为英文原文

Flash: Air Suspension Control Module (ASCM) Updates This bulletin involves reprogramming the ASCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or moreof the following DTCs have been set: U0132 - Loss of Communication with Air Suspension Control Module. C15E1-97 - Left Rear Air Spring Intake - Component or System Operation Obstructedor Blocked. C220C-48 - Active Suspension Module Internal-Supervision Software Failure(2019 MY Only). C211B-92 - Ignition Run/Start Input-Performance Or Incorrect Operation(2019 MY Only). C156C-7A - Ride Height System Air Leak-Fluid Leak Or Seal Failure(2019 MY Only). In addition the customer may describe: Air spring deflated or ruptured. Right/left rear suspensions sits lower than the other side. During key ?On? or while driving, the ?service air suspension?light illuminates. Chime and "Service Air Suspension Immediately" message appeared in the clusterfor 5 seconds. Air suspension system is inoperable. Excessive operation or noise from air suspension system when vehicle is stationary(2019 MY Only). "Air Suspension Disabled" message when attempting Bed Lowering Mode (BLM)(2019 MY Only). Excessive compressor valve cycling following a cold start(2019 MY with Diesel engine only). Erroneous "Bed Low Achieved" message through the Instrument Panel Cluster (IPC), when requesting lowering, even though the truck didn'tphysically lower. Ride height changes/valve actuations without operator request on rough roads.

仅当厂商、通报编号、发布日期和完整摘要一致时，重复登记才会合并展示，原始编号仍予保留。旧资料继续供查阅；确认明确替代关系后才标示后续版本。1994 年以前的车辆关联与默认结果分开显示；未注明年款不等于适用于所有年款。