JEEP

18-086-24

2024-12-11 · NHTSA 11011903

车型关联可作为查阅线索；具体发动机、生产范围和软件条件请核对厂商资料。

厂商摘要

以下为英文原文

"Flash: Powertrain Control Module (PCM) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● **P0325 - Knock/Combustion Vibration Sensor ""A"" Circuit. ● P0330 - Knock/Combustion Vibration Sensor ""B"" Circuit. ● P0300 - Multiple Cylinder Misfire. (NA Market Only) ● P032A - Knock/Combustion Vibration Sensor ""C"" Circuit. ● P018B - Fuel Pressure Sensor ""B"" Circuit Rang/Performance. ● P1CEA - Boost Side EVAP Purge System Performance. (NA Market Only)** ● P00F3 - Humidity Sensor Circuit Range/Performance. ● P06DD - Engine Oil Pressure Control Circuit Performance/Stuck Off. ● P00C6 - Fuel Rail Pressure Too Low - Engine Cranking. Customers may also comment on one or more of the following: ● **Low oil pressure Instrument Cluster Panel (IPC) warning during heavy towing. ● Engine RPM dip below idle speed during coast down to idle.** ● Undesirable vehicle drivability behavior causing a vehicle Shift to Park event during Engine Stop Start (ESS) while Adaptive Cruise Control (ACC) is active. ● Idle speed oscillations observed when in Snow and Mud modes for vehicle configured with 4x2 drivetrain. ● Screen two incorrectly pops up on the IPC for five seconds during Terrain and Rock mode. ● Fully Autonomous Parking Assist (FAPA) is not deactivated when the accelerator pedal is pressed. ● Vehicle is not heating up fast enough at freezing temperatures. **The following software calibration improvements are also available: ● Engine mega knock detection. ● Misfire during cold start. ● Avoid false failures with MIL on. (NA Market Only)** This bulletin involves reprogramming the PCM with the latest available software."

仅当厂商、通报编号、发布日期和完整摘要一致时，重复登记才会合并展示，原始编号仍予保留。旧资料继续供查阅；确认明确替代关系后才标示后续版本。1994 年以前的车辆关联与默认结果分开显示；未注明年款不等于适用于所有年款。