MERCEDES-BENZ

LI15.18-P-078654

2024-12-20 · NHTSA 11012059

车型关联可作为查阅线索；具体发动机、生产范围和软件条件请核对厂商资料。

厂商摘要

以下为英文原文

Complaint Engine warning light active. Fault code P012D12 The pressure sensor upstream of exhaust gas turbocharger has short circuit to positive. There is a short circuit to positive. is stored in the control unit N3/10 N3/10 - engine electronics 'MED41''M264'. Cause In the course of a pre-repair, the lines may be damaged due to the feed line to component part B28/11 pressure sensor downstream of air filter being routed too taut. (see picture 1) Remedy 1. Attach 12 V charger Note: An adequate voltage from the on-board electrical system battery must be guaranteed for the entire duration of the work procedure. Otherwise the control units could be damaged if an undervoltage occurs. Information: Observe the operating instructions of the 12 V charger. Information: Use the 12 V charger to ensure a sufficient voltage (minimum 12.5 V) from the on-board electrical system battery. -------------------------------------------------------------------------------------------------------------------------------- 2. Attach diagnostic system Information: Always ensure that XENTRY Diagnosis is updated to the latest version. For further information on "Retail Data Storage", see the Service Information bulletin SI00.01-D-0044SG. Information: The operation steps in XENTRY Diagnosis must be complied with precisely at all times. -------------------------------------------------------------------------------------------------------------------------------- 3. Carry out quick test and read out fault memory Information: If the above-mentioned fault code (P012D12) is stored in the control unit ME (N3/10) continue with operation step 4. -------------------------------------------------------------------------------------------------------------------------------- 4. Check line installation of component part B28/11 pressure sensor downstream of air filter for damage and routing free of tension. Repair defective lines as per XENTRY WIS. Note: Routing of the feed line free of tension must be ensured. (See picture 2)

仅当厂商、通报编号、发布日期和完整摘要一致时，重复登记才会合并展示，原始编号仍予保留。旧资料继续供查阅；确认明确替代关系后才标示后续版本。1994 年以前的车辆关联与默认结果分开显示；未注明年款不等于适用于所有年款。