RAM

9100487

2025-01-15 · NHTSA 11012866

车型关联可作为查阅线索；具体发动机、生产范围和软件条件请核对厂商资料。

厂商摘要

以下为英文原文

MODULE Steering Control Before replacing the steering column control module (SCCM) due to turn signal inop, wipers inop, steering controls inop, TCS light DTC C0051 or horn blowing while turning, please follow these steps: 1.- Refer to service library procedure and follow diagnosis steps. 2.- If failure still present, make sure all the switches', horn's, airbag's harness are properly connected and there is no corrosion or pinching, disconnect the switches & reconnect them, and reverify the issue. 3.- Verify if failure is still present, review if there is lack of communication between SCCM and BCM. For example, activate turn signals or wipers. 4.- Read at the BCM diagnosis session if BCM is receiving information from SCCM. Through diagnosis review if activation from horn, wipers or turn signal is requested and are working. 5.- Disconnect the SCCM fuse for around 30s,and repeat the previous steps to see if failure still present. 6.- Do a hard reset to BCM and evaluate if any DTC is set. Retest if failure still present. 7.- Before replacing the SCCM disconnect it and reconnect it again. If there are no DTC's active, physical defects, steering controls inop, wipers inop, nor turn signal inop, horn inop, then SCCM does not need to be replaced.

仅当厂商、通报编号、发布日期和完整摘要一致时，重复登记才会合并展示，原始编号仍予保留。旧资料继续供查阅；确认明确替代关系后才标示后续版本。1994 年以前的车辆关联与默认结果分开显示；未注明年款不等于适用于所有年款。