MERCEDES-BENZ

LI72.40-P-065822

2025-01-24 · NHTSA 11013307

车型关联可作为查阅线索；具体发动机、生产范围和软件条件请核对厂商资料。

厂商摘要

以下为英文原文

Complaint - Power window reverses direction on reaching upper end position. - Power window inoperative, fault code P060A64 / B18C12A / B192015 is stored in fault memory of door control unit. Cause - Software error in door control unit (N69/X). - Power window motor(s) on front door, left (M10/3) and/or front door, right (M10/4) => On vehicles with CODE 808, 809 or 800. Remedy 1.) Read out hardware version of affected door control unit (N69/X) using quick test (see Figure 1). => For door control units with hardware version equal to/higher than 16/20 (year/week), continue with operation step 2. => For door control units with hardware versions 13/49, 14/23, 14/24 and 14/30, continue with operation step 3. 2.) Replace affected power window motor (M10/X). IMPORTANT NOTE (see also SI document under WIS reference): For vehicles with CODE 808, 809 or 800, the only motors in stock are the new power window motors with modified carbon brushes for the front doors. For this reason, when replacing the power window motor left front door (M10/3) or the front right power window motor, it is also essential to adapt the power window parameters in the corresponding control unit, front door, left (N69/1) or control unit, front door, right (N69/2). When doing so, the following procedure must be followed: a) Replace power window motor(s) on front door, left (M10/3) and/or right (M10/4). b) Carry out commissioning of the door control unit(s) for the front door, left (N69/1) and/or right (N69/2) using Xentry Diagnostics. c) Then perform a function test on the power window system by operating the power window switch in the direction of "AUTOMATIC DOWN" and "AUTOMATIC UP"to fully open and close the side window. Note: Only replace the power window motor if the door control unit hardware version is 16/20! 3.) Perform commissioning of affected door control unit. (Path: Xentry Diagnostics => Control units view => DCU-XX (N69/X) => Adaptations => Commission) Note: Since 09.08.2018, a new SCN coding is available for the current software release! Commissioning ensures that the door control unit receives the current software release and the new SCN coding.

仅当厂商、通报编号、发布日期和完整摘要一致时，重复登记才会合并展示，原始编号仍予保留。旧资料继续供查阅；确认明确替代关系后才标示后续版本。1994 年以前的车辆关联与默认结果分开显示；未注明年款不等于适用于所有年款。