MERCEDES-BENZ, MERCEDES-MAYBACH

LI54.10-P-079534

2025-08-08 · NHTSA 11021802

车型关联可作为查阅线索；具体发动机、生产范围和软件条件请核对厂商资料。

厂商摘要

以下为英文原文

Complaint: Red 12 V battery warning message in IC DTC stored in EZS or currently: B161609 No DTC in DC/DC converter DC/DC converter is not providing any output voltage or output current Cause: Due to a reduction in resistance at the HV voltage divider, the DC/DC converter measures an incorrect HV voltage. Regulation of the 12 V output voltage is therefore unstable or turns off. Remedy: Check of the DC/DC converter via XENTRY Diagnosis Actuate BUCK mode for approx. 40 s Normally, the output current will jump up to a high value (e.g. 100 A) and then slowly drop to the current specified value (e.g. 50 A) and then only change slowly and in small increments (video in attachment). In the event of this error cause, the DC/DC converter may react in two possible ways: 1) Despite displayed BUCK mode, the DC/DC converter does not provide any output voltage or output current (video in attachment). 2) The output voltage and output current may experience significant fluctuations/jumps (several 1-10 A) (video in attachment). Perform in XENTRY -> DC/DC converter N83/1 -> Special procedures -> "Evaluation of the HV resistance reduction of the DC/DC converter control unit". The special procedure compares the serial number of the installed DC/DC converter with the list of potentially affected parts. Depending on the result: If the serial number can be found in the list of potentially affected component parts, then replace the DC/DC converter. If the serial number cannot be found in the list of potentially affected parts but the problem described applies, then please open a TIPS case and forward to HQ.

仅当厂商、通报编号、发布日期和完整摘要一致时，重复登记才会合并展示，原始编号仍予保留。旧资料继续供查阅；确认明确替代关系后才标示后续版本。1994 年以前的车辆关联与默认结果分开显示；未注明年款不等于适用于所有年款。